Search results
Results From The WOW.Com Content Network
A typical motor start capacitor. A motor capacitor [1] [2] is an electrical capacitor that alters the current to one or more windings of a single-phase alternating-current induction motor to create a rotating magnetic field. [citation needed] There are two common types of motor capacitors, start capacitor and run capacitor (including a dual run ...
Humming can also be caused by a bad start/run capacitor, or a capacitor with a wrong capacitance size for the motor. A bad or wrong start/run capacitor causes the winding current phase on main windings and auxiliary windings to not sync properly and can cause a hum. Also, humming may be reduced by having windings varnished.
Leads separated from the capacitor by rough handling during storage, assembly or operation, leading to an open failure. The failure can occur invisibly inside the packaging and is measurable. [2] Increase of dissipation factor due to contamination of capacitor materials, particularly from flux and solvent residues. [2]
For premium support please call: 800-290-4726 more ways to reach us
These motors are sometimes called DC motors, sometimes EC motors and occasionally DC/EC motors. DC stands for direct current and EC stands for electronically commutated.. DC motors allow the speed of the fans within a fan coil unit to be controlled by means of a 0-10 Volt input control signal to the motor/s, the transformers and speed switches associated with AC fan coils are not required.
A discharged or partially charged capacitor appears as a short circuit to the source when the source voltage is higher than the potential of the capacitor. A fully discharged capacitor will take approximately 5 RC time periods to fully charge; during the charging period, instantaneous current can exceed steady-state current by a substantial ...
Squeezing the dielectric can change a capacitor at a few tens of bar pressure sufficiently that it can be used as a pressure sensor. [83] A selected, but otherwise standard, polymer dielectric capacitor, when immersed in a compatible gas or liquid, can work usefully as a very low cost pressure sensor up to many hundreds of bar.
Since intermittent faults are not easily repeatable, it is more difficult to conduct a failure analysis for them, understand their root causes, or isolate their failure site than it is for permanent failures. [1] Intermittent failures can be a cause of no-fault-found (NFF) occurrences in electronic products and systems. NFF implies that a ...