Search results
Results From The WOW.Com Content Network
The TCP algorithm is unaware the link is congested and does not start to take corrective action until the buffer finally overflows and packets are dropped. All packets passing through a simple buffer implemented as a single queue will experience similar delay, so the latency of any connection that passes through a filled buffer will be affected.
Jitter is the undesired deviation from true periodicity of an assumed periodic signal in electronics and telecommunications, often in relation to a reference clock source. Jitter may be observed in characteristics such as the frequency of successive pulses, the signal amplitude , or phase of periodic signals.
In computer networking, packet delay variation (PDV) is the difference in end-to-end one-way delay between selected packets in a flow with any lost packets being ignored. [1] The effect is sometimes referred to as packet jitter , although the definition is an imprecise fit.
Check the physical connection - A loose cable or cord can often be the cause of a connection problem. Make sure everything is securely connected to the wall and device. 3. Reboot your modem/router - Sometimes the old "turn it off and on again" approach actually does work! Just wait about five minutes before turning it back on to make sure ...
In the context of computer networks, packet jitter or packet delay variation (PDV) is the variation in latency as measured in the variability over time of the end-to-end delay across a network. A network with constant delay has no packet jitter. [11] Packet jitter is expressed as an average of the deviation from the network mean delay. [12]
In the early 1990s, Charles Perkins from SUN Microsystems USA, and Chai Keong Toh from Cambridge University separately started to work on a different Internet, that of a wireless ad hoc network. Perkins was working on the dynamic addressing issues. Toh worked on a new routing protocol, which was known as ABR – associativity-based routing. [8]
Quality of service (QoS) is the description or measurement of the overall performance of a service, such as a telephony or computer network, or a cloud computing service, particularly the performance seen by the users of the network.
Connection points between a local area network and a wide area network are common choke points. When a network is in this condition, it settles into a stable state where traffic demand is high but little useful throughput is available, during which packet delay and loss occur and quality of service is extremely poor.