Search results
Results From The WOW.Com Content Network
Geofoam was first used in the United States in 1989 on Highway 160 between Durango and Mancos, Colorado. An increase in rainfall caused a landslide, destroying part of the highway. Geofoam was used to create highway side slope stabilization to prevent any similar issues. The use of geofoam versus conventional restoration resulted in an 84% ...
Drainage is the equilibrium soil-to-geosynthetic system that allows for adequate liquid flow without soil loss, within the plane of the geosynthetic over a service lifetime compatible with the application under consideration. Geopipe highlights this function, and also geonets, geocomposites and very thick geotextiles.
Precast concrete retaining wall A typical cross-section of a slope used in two-dimensional analyzes. Geotechnical engineering, also known as geotechnics, is the branch of civil engineering concerned with the engineering behavior of earth materials. It uses the principles of soil mechanics and rock mechanics to solve its engineering problems.
Soil mechanics is a branch of soil physics and applied mechanics that describes the behavior of soils. It differs from fluid mechanics and solid mechanics in the sense that soils consist of a heterogeneous mixture of fluids (usually air and water) and particles (usually clay , silt , sand , and gravel ) but soil may also contain organic solids ...
Centrifuge tests can also be used to obtain experimental data to verify a design procedure or a computer model. The rapid development of computational power over recent decades has revolutionized engineering analysis. Many computer models have been developed to predict the behavior of geotechnical structures during earthquakes and other loads.
The two main disciplines of geomechanics are soil mechanics and rock mechanics.Former deals with the soil behaviour from a small scale to a landslide scale. The latter deals with issues in geosciences related to rock mass characterization and rock mass mechanics, such as applied to petroleum, mining and civil engineering problems, such as borehole stability, tunnel design, rock breakage, slope ...
This behavior, critical state soil mechanics simply assumes as a given. For these reasons, critical-state and elasto-plastic soil mechanics have been subject to charges of scholasticism; the tests to demonstrated its validity are usually "conformation tests" where only simple stress-strain curves are demonstrated to be modeled satisfactorily.
In geotechnical engineering, a discontinuity (often referred to as a joint) is a plane or surface that marks a change in physical or chemical characteristics in a soil or rock mass. A discontinuity can be, for example, a bedding, schistosity, foliation, joint, cleavage, fracture, fissure, crack, or fault plane.