Ads
related to: brick veneer slab edge detail drawing
Search results
Results From The WOW.Com Content Network
Because the masonry veneer is non-structural, it must be tied back to the building structure to prevent movement under wind and earthquake loads. Brick ties are used for this purpose, and may take the form of corrugated metal straps nailed or screwed to the structural framing, or as wire extensions to horizontal joint reinforcement in a fully masonry veneer or cavity wall.
Incomplete firestop in the perimeter slab edge, made of rockwool without topcaulking. Firestopping at the perimeter slab edge, which is a gap between the floor and the curtain wall, is essential to slow the passage of fire and combustion gases between floors. Spandrel areas must have non-combustible insulation at the interior face of the ...
Course (architecture) A course is a layer of the same unit running horizontally in a wall. It can also be defined as a continuous row of any masonry unit such as bricks, concrete masonry units (CMU), stone, shingles, tiles, etc. [1] Coursed masonry construction arranges units in regular courses. Oppositely, coursed rubble masonry construction ...
Rainscreen. A rainscreen is an exterior wall detail where the siding (wall cladding) stands off from the moisture - resistant surface of an air/water barrier applied to the sheathing to create a capillary break and to allow drainage and evaporation. The rainscreen is the cladding or siding itself [1] but the term rainscreen implies a system of ...
Tilt-up, tilt-slab or tilt-wall is a type of building and a construction technique using concrete. Though it is a cost-effective technique with a shorter completion time, [ 1 ] poor performance in earthquakes has mandated significant seismic retrofit requirements in older buildings.
A "face brick" is a higher-quality brick, designed for use in visible external surfaces in face-work, as opposed to a "filler brick" for internal parts of the wall, or where the surface is to be covered with stucco or a similar coating, or where the filler bricks will be concealed by other bricks (in structures more than two bricks thick).