Ads
related to: plain sliced vs flat cut veneer
Search results
Results From The WOW.Com Content Network
This yields veneer that looks like sawn pieces of wood, cut across the growth rings; such veneer is referred to as "crown cut". A half-round lathe in which the log or piece of log can be turned and moved in such a way as to expose the most interesting parts of the grain, creating a more textured feel and appearance; such veneer is commonly ...
Lumber produced by flat sawing from a log. Plank A has been cut from the middle, and is as wide as the original log. Plank B has been cut closer to the side, and shows slash grain. Flat sawing, flitch sawing or plain sawing is a woodworking process that produces flat-cut or plain-cut boards of lumber. [1]
A long and flat steel tool with raised teeth for shaping wood. reed A series of beads arranged in a row. relief cut A short, straight cut made at a right angle to a curved layout so that sharper-than-normal curves can be cut with a jig saw or band saw. riffler A paddle-shaped rasp. rift sawn
When boards are cut from a log, they are usually rip cut along the length (axis) of the log. This can be done in three ways: plain-sawing (most common, also known as flat-sawn, bastard-sawn, through and through, and tangent-sawn), quarter-sawing (less common), or rift sawing (rare).
Plain sawn (flat sawn, through and through, bastard sawn) – A log sawn through without adjusting the position of the log and the grain runs across the width of the boards. Quarter sawn and rift sawn – These terms have been confused in history but generally mean lumber sawn so the annual rings are reasonably perpendicular to the sides (not ...
Diagonal- and stepped-cut rift-sawing is intermediate to flat-sawn and radial cut lumber. The angle of the bastard grain may differ along the width of the board or between opposing sides, and enhances the appearance of ray fleck. Flat-sawing is the quickest method, producing the least wood waste and largest possible boards from a log.
The simplest kind of marquetry uses only two sheets of veneer, which are temporarily glued together and cut with a fine saw, producing two contrasting panels of identical design, (in French called partie and contre-partie, "part" and "counterpart"). Marquetry as a modern craft most commonly uses knife-cut veneers.
The lengths of the log sections are based on the veneer sizes required for the orders. In the peeling line, the peeling blade is led with high pressure against the rotating log section. The result is a continuous veneer strip which is cut into the required widths. You can create veneers with thicknesses of 0.6 mm to 2.3 mm.