Search results
Results From The WOW.Com Content Network
Pierce [4] undertook an analysis of the effects of amplifier damping factor on the decay time and frequency-dependent response variations of a closed-box, acoustic suspension loudspeaker system. The results indicated that any damping factor over 10 is going to result in inaudible differences between that and a damping factor equal to infinity.
However, the unitless damping factor (symbol ζ, zeta) is often a more useful measure, which is related to α by = . The special case of ζ = 1 is called critical damping and represents the case of a circuit that is just on the border of oscillation. It is the minimum damping that can be applied without causing oscillation.
Damping not based on energy loss can be important in other oscillating systems such as those that occur in biological systems and bikes [4] (ex. Suspension (mechanics)). Damping is not to be confused with friction, which is a type of dissipative force acting on a system. Friction can cause or be a factor of damping.
The logarithmic decrement can be obtained e.g. as ln(x 1 /x 3).Logarithmic decrement, , is used to find the damping ratio of an underdamped system in the time domain.. The method of logarithmic decrement becomes less and less precise as the damping ratio increases past about 0.5; it does not apply at all for a damping ratio greater than 1.0 because the system is overdamped.
The Q factor is a parameter that describes the resonance behavior of an underdamped harmonic oscillator (resonator). Sinusoidally driven resonators having higher Q factors resonate with greater amplitudes (at the resonant frequency) but have a smaller range of frequencies around that frequency for which they resonate; the range of frequencies for which the oscillator resonates is called the ...
The amplifier damping factor, which is the ratio of the nominal load impedance (driver voice coil) to amplifier output impedance, is adequate in either case for well-designed solid state amplifiers. Tube amplifiers have sufficiently higher output impedances that they normally included multi-tap output transformers to better match to the driver ...
The damping ratio of an oscillating system in engineering and physics [6] The rotational quantity of angular jerk in physics [7] The effective nuclear charge on an electron in quantum chemistry; The electrokinetic potential in colloidal systems [8] The lag angle in helicopter blade dynamics [9] Relative vorticity in the atmosphere and ocean
The lesser the transmissibility the better is the damping or the isolation system. T < 1 {\displaystyle T<1} is Desirable, T = 1 {\displaystyle T=1} acts as a rigid body, T > 1 {\displaystyle T>1} is Undesirable