Ads
related to: t nut dimension chart guitar scale printable ruler pdf
Search results
Results From The WOW.Com Content Network
A multi-scale fingerboard or fretboard is typically based on two scale lengths, but could potentially incorporate more. The most typical use is one (long) scale length for the low string and a different, usually shorter, scale for the highest string. This could be achieved by angling the nut, and bridge, and fanning the frets. Strings between ...
For example, a 7/8 violin has a scale of about 317 mm, a 3/4-size instrument a scale of 307 mm, a half-size one 287 mm, and a quarter-size one 267 mm. 1/8, 1/10, 1/16 and 1/32 and even 1/64 violins also exist, becoming progressively smaller, but again in no proportional relationship. (A full-size instrument is described as 4/4.)
Fretted classical guitar fingerboard Fretless violin fingerboard The fingerboard (also known as a fretboard on fretted instruments) is an important component of most stringed instruments . It is a thin, long strip of material, usually wood, that is laminated to the front of the neck of an instrument.
T-nuts. The left one has been inserted in the wood and a bolt has been screwed in from the other side. A T-nut, T nut, or tee nut (also known as a blind nut, [1] which can however also refer to a rivet nut or an insert nut, and likewise drive-in nut [2]) is a type of nut used to fasten a wood, particle or composite materials workpiece, leaving a flush surface.
A variety of rulers A carpenter's rule Retractable flexible rule or tape measure A closeup of a steel ruler A ruler in combination with a letter scale. A ruler, sometimes called a rule, scale or a line gauge or metre/meter stick, is an instrument used to make length measurements, whereby a length is read from a series of markings called "rules" along an edge of the device. [1]
The major diameter is given by 6p 1.2, [4]: 12 rounded to two significant figures in mm and the hex head size (across the flats) is 1.75 times the major diameter. BA sizes are specified by the following British Standards: BS 57:1951 — B.A. screws, bolts and nuts