When.com Web Search

  1. Ads

    related to: pontiac cam bearing tool

Search results

  1. Results From The WOW.Com Content Network
  2. Pontiac straight-6 engine - Wikipedia

    en.wikipedia.org/wiki/Pontiac_Straight-6_engine

    The Pontiac's single camshaft was supported by journals within the aluminum valve cover; no separate bearing shells were used. The cam was driven by a noise-reducing fiberglass-reinforced cogged rubber belt instead of the usual metal chain or gears. Valves were opened with finger followers (centered under the cam) that pivoted at one end on ...

  3. Timing belt (camshaft) - Wikipedia

    en.wikipedia.org/wiki/Timing_belt_(camshaft)

    The 1966 Pontiac OHC Six engine was the first US mass-produced vehicle to use a timing belt, [21] [22] while the 1966 Fiat Twin Cam engine was the first mass-produced engine to use a timing belt with twin camshafts. Carmakers began to adopt timing belts in the 1970s and compared to timing chains are less expensive, smaller, lighter, quieter ...

  4. Pontiac V8 engine - Wikipedia

    en.wikipedia.org/wiki/Pontiac_V8_engine

    Though a change of camshaft would delay production, Pontiac decided to change camshaft, employing one with identical timing to the 744 camshaft, which had been used in the 400 Ram Air(aka Ram Air III) engine with manual transmissions. As a result, peak horsepower dropped from 310 to 290, though torque increased from 390 to 395 lb. ft.

  5. General Motors 60° V6 engine - Wikipedia

    en.wikipedia.org/wiki/General_Motors_60°_V6_engine

    The LQ1 (also called the Twin Dual Cam or TDC) was a 3.4 L (3,350 cc) DOHC V6 engine ("X-code") based on the aluminum-headed second generation of GM's 60° engine line, sharing a similar block with its pushrod cousins, the 3.1 L LH0 V6 and the then recently retired 2.8 L (2,837 cc) LB6 V6.

  6. GMC straight-6 engine - Wikipedia

    en.wikipedia.org/wiki/GMC_Straight-6_engine

    GMC replaced the Pontiac 223 with their own 228-cubic-inch (3.7 L) 228 in 1939. This OHV (overhead valve) engine was produced through 1953. With a cylinder bore of 3.5625 inches (90.49 mm), this is the smallest low-deck engine. All four low-deck engines have a stroke of 3.8125 inches (96.84 mm) and used 7 inch long connecting rods.

  7. Discover the latest breaking news in the U.S. and around the world — politics, weather, entertainment, lifestyle, finance, sports and much more.

  1. Ad

    related to: pontiac cam bearing tool