Search results
Results From The WOW.Com Content Network
Michelson and Morley (1887) [28] and other early experimentalists using interferometric techniques in an attempt to measure the properties of the luminiferous aether, used monochromatic light only for initially setting up their equipment, always switching to white light for the actual measurements. The reason is that measurements were recorded ...
The only differences are an interferometric objective lens and an accurate positioning stage (a piezoelectric actuator) to move the objective vertically. The optical magnification of the image on the CCD does not depend on the distance between tube lens and objective lens if the microscope images the object at infinity.
GNSS Interferometric Reflectometry (or GNSS-IR) is a specialized case of GNSS-R. Here the receiving instrument is on the surface of the Earth. In this technique the interference of the direct and reflected signals is used rather than a Delay Doppler Map or measuring the two signals separately.
The other interferometer arm is bounced off a reference mirror. Reflected light from the tissue sample is combined with reflected light from the reference. Because of the low coherence of the light source, interferometric signal is observed only over a limited depth of sample.
Optical coherence tomogram of a fingertip. It is possible to observe the sweat glands, having "corkscrew appearance" Interferometric reflectometry of biological tissue, especially of the human eye using short-coherence-length light (also referred to as partially-coherent, low-coherence, or broadband, broad-spectrum, or white light) was investigated in parallel by multiple groups worldwide ...
Interferometric synthetic-aperture radar (a radar-based 3-d surface mapping) Superconducting quantum interference devices (SQUIDs) White–Juday warp-field interferometer
Main page; Contents; Current events; Random article; About Wikipedia; Contact us
Figure 1. Fizeau interferometer. A Fizeau interferometer [1] is an interferometric arrangement whereby two reflecting surfaces are placed facing each other. As seen in Fig 1, the rear-surface reflected light from the transparent first reflector is combined with front-surface reflected light from the second reflector to form interference fringes.