Ads
related to: installing car audio guide dual amps with capacitor
Search results
Results From The WOW.Com Content Network
Capacitors. Mobile audio power amplifiers. Amplifiers increase the power level of audio signals. Some head units have built-in stereo amplifiers. Other car audio systems use a separate stand-alone amplifier. Every amplifier has a rated power level sometimes noted on the head unit with the built-in amplifier, or on the label of a stand-alone unit.
Constant-voltage speaker systems refer to networks of loudspeakers which are connected to an audio amplifier using step-up and step-down transformers to simplify impedance calculations and to minimize power loss over the speaker cables. They are more appropriately called high-voltage audio distribution systems. [1]
A bridge-tied load (BTL), also known as bridged transformerless and bridged mono, is an output configuration for audio amplifiers, a form of impedance bridging used mainly in professional audio & car applications. [1] The two channels of a stereo amplifier are fed the same monaural audio signal, with one channel's electrical polarity reversed.
The term loudspeaker may refer to individual transducers (also known as drivers) or to complete speaker systems consisting of an enclosure and one or more drivers.. To adequately and accurately reproduce a wide range of frequencies with even coverage, most loudspeaker systems employ more than one driver, particularly for higher sound pressure level (SPL) or maximum accuracy.
The capacitors act as a local reserve for the DC power source, and bypass AC currents from the power supply. This is used in car audio applications, when a stiffening capacitor compensates for the inductance and resistance of the leads to the lead-acid car battery.
The output audio signal is received though a DC blocking capacitor. An electret microphone is a microphone whose diaphragm forms a capacitor (historically-termed a condenser) that incorporates an electret. The electret's permanent electric dipole provides a constant charge Q on the capacitor.
The capacitor value must be made large enough that this filter passes the lowest frequency of interest. For audio amplifiers, this value can be relatively large, but at radio frequencies it is a small component of insignificant cost compared to the overall amplifier. Transformer coupling is an alternative AC coupling.
Also, in a DC steady state, an ideal capacitor acts as an open circuit. The DC gain of the ideal circuit is therefore infinite (or in practice, the open-loop gain of a non-ideal op-amp). Any DC (or very low frequency) component may then cause the op amp output to drift into saturation. [3]