Ads
related to: das kit throttle assembly replacement parts youtubepartstown.com has been visited by 10K+ users in the past month
Search results
Results From The WOW.Com Content Network
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
The predecessor of modern electronic traction control systems can be found in high-torque, high-power rear-wheel-drive cars as a limited slip differential.A limited-slip differential is a purely mechanical system that transfers a relatively small amount of power to the non-slipping wheel, while still allowing some wheel spin to occur.
In fuel injected engines, the throttle body is the part of the air intake system that controls the amount of air flowing into the engine, in response to driver accelerator pedal input in the main. The throttle body is usually located between the air filter box and the intake manifold, and it is usually attached to, or near, the mass airflow sensor.
Powershifting, also known as full-throttle shifting or flat-shifting, is a method of gear shifting used with manual transmissions to reduce the time where the driving wheels are not powered. Unlike during a normal gear change, in a powershift the driver does not let off the accelerator.
The 318 cu in (5.2 L) V8, was the only available engine. 1981 models came standard with a Chrysler-built throttle-body EFI system, replaced by a carburetor for 1982 and 1983 models. The automatic transmission was a wide-ratio TorqueFlite equipped with lock-up torque converter , [ 54 ] with the final drive ratio 2.2:1 in 1981 and 1983; 2.4:1 in ...
AOL latest headlines, entertainment, sports, articles for business, health and world news.
During that time, the Model A and AA engine cylinder block (part number A-6010), went through various external and internal changes. [ 15 ] [ 16 ] The Model A was replaced by the 1932 Ford Model B , with an updated 4-cylinder engine, and by the 1932 Ford Model 18 , with its new Ford V8 engine.
Some systems also use a differential pressure controller which senses the air pressures on either side of the throttle plate and adjusts the wastegate to maintain a set differential. This maintains an optimum balance between a low turbocharger workload and a quick spool-up time, and also prevents surging caused by a bootstrapping effect.