When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Below is a comprehensive drill and tap size chart for all drills and taps: Inch, imperial, and metric, up to 36.5 millimetres (1.44 in) in diameter. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.

3. Metric drill bit sizes - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_sizes

   ANSI B94.11M-1979 sets size standards for jobber-length straight-shank twist drill bits from 1/64 inch through 1 inch in 1/64 inch increments. For Morse taper -shank drill bits, the standard continues in 1/64 inch increments up to 1¾ inch, then 1/32 inch increments up to 2¼ inch, 1/16 inch increments up to 3 inches, 1/8 inch increments up to ...

4. ANSI/ASME Y14.1 - Wikipedia

   en.wikipedia.org/wiki/ANSI/ASME_Y14.1

   A size chart illustrating the ANSI sizes. In 1992, the American National Standards Institute adopted ANSI/ASME Y14.1 Decimal Inch Drawing Sheet Size and Format, [1] which defined a regular series of paper sizes based upon the de facto standard 8 + 1 ⁄ 2 in × 11 in "letter" size to which it assigned the designation "ANSI A".

5. Unified Thread Standard - Wikipedia

   en.wikipedia.org/wiki/Unified_Thread_Standard

   Imperial Metric fastening size conversion charts; International Thread Standards; Conversion chart Whitworth/BSF/AF and metric Archived 2 May 2010 at the Wayback Machine; Spanner Jaw Sizes Additional information and spanner jaw size table. Unified Screw Threads Series; ASME B1.1-2003 Unified Inch Screw Threads, (UN and UNR Thread Form)

6. United States customary units - Wikipedia

   en.wikipedia.org/wiki/United_States_customary_units

   There are anecdotal objections to the use of metric units in carpentry and the building trades, on the basis that it is easier to remember an integer number of inches plus a fraction, rather than a measurement in millimeters, [9] or that foot-inch measurements are more suitable when distances are frequently divided into halves, thirds, and ...

7. Unit of length - Wikipedia

   en.wikipedia.org/wiki/Unit_of_length

   A ruler, depicting two customary units of length, the centimeter and the inch. A unit of length refers to any arbitrarily chosen and accepted reference standard for measurement of length. The most common units in modern use are the metric units, used in every country globally.

8. Help:Convert units - Wikipedia

   en.wikipedia.org/wiki/Help:Convert_units

   Special rounding of the inches value only occurs when "hand in" is the output. For example, if the output is "in hand", the inches value is rounded independently from the hands value. {{convert|156|cm|hand in}} → 156 centimetres (15.1 hands ; 61 in)

9. Photo print sizes - Wikipedia

   en.wikipedia.org/wiki/Photo_print_sizes

   The alternative Super series, denoted SnR, nR Plus or nR+, has an aspect ratio of 3∶2 (or as close as possible) and thus provides a better fit for standard 135 film (35 mm) at sizes of 8 inches or above. 5R is twice the size of a 2R print, 6R twice the size of a 4R print and S8R twice the size of 6R. 4D/6D is a newer size for most consumer ...