Ad
related to: motorola ic data sheets free
Search results
Results From The WOW.Com Content Network
68HC11 block diagram. Internally, the HC11 instruction set is backward compatible with the 6800 and features the addition of a Y index register. [a] It has two eight-bit accumulators, A and B, two sixteen-bit index registers, X and Y, a condition code register, a 16-bit stack pointer, and a program counter.
Motorola 6845 CRT controller. The Motorola 6845, or MC6845, is a display controller that was widely used in 8-bit computers during the 1980s. [1] [2] Originally intended for designs based on the Motorola 6800 CPU and given a related part number, it was more widely used alongside various other processors, and was most commonly found in machines based on the Zilog Z80 and MOS 6502.
The PIA is designed for glueless connection to the Motorola 6800 style bus, and provides 20 I/O lines, which are organised into two 8-bit bidirectional ports (or 16 general-purpose I/O lines) and 4 control lines (for handshaking and interrupt generation). The directions for all 16 general lines (PA0-7, PB0-7) can be programmed independently.
The 68HC08 (also abbreviated as HC08) is a broad family of 8-bit microcontrollers from Motorola Semiconductor (later from Freescale then NXP). HC08's are fully code-compatible with their predecessors, the Motorola 68HC05. Like all Motorola processors that share lineage from the 6800, they use the von Neumann architecture as
Like the 68HC11, the 68HC12 has two 8-bit accumulators A and B (referred to as a single 16-bit accumulator, D, when A & B are cascaded so as to allow for operations involving 16 bits), two 16-bit registers X and Y, a 16-bit program counter, a 16-bit stack pointer and an 8-bit Condition Code Register.
The 68HC05 (also abbreviated as HC05) is a broad family of 8-bit microcontrollers from Motorola Semiconductor (later Freescale then NXP). Like all Motorola processors that share lineage from the 6800 , they use the von Neumann architecture as well as memory-mapped I/O.
Typical n-channel MOS IC's required three power supplies: −5 volts, +5 volts and +12 volts. The M6800 family was to use only one, +5 volts. It was easy to eliminate the −5 volt supply by using an internal voltage inverter, but the enhancement-mode logic also needed a supply of 10 to 12 volts. To address this, the design added an on-chip ...
The ICU was conceived by Vern Gregory in the mid-1970s while working as an engineer in a marketing / applications group of Motorola Semiconductor Products Sector in Phoenix, Arizona, USA; Brian Dellande originated circuit and sub-routine designs, and co-wrote the manual; Ray DiSilvestro was the bench technician; Terry Malarkey provided management support.