Ads
related to: replace drywall ceiling with wood
Search results
Results From The WOW.Com Content Network
Lath and plaster is a building process used to finish mainly interior dividing walls and ceilings. It consists of narrow strips of wood which are nailed horizontally across the wall studs or ceiling joists and then coated in plaster. The technique derives from an earlier, more primitive process called wattle and daub. [1]
Various sized cuts of 1 ⁄ 2 in (13 mm) drywall with tools for maintenance and installation . Drywall (also called plasterboard, dry lining, [1] wallboard, sheet rock, gib board, gypsum board, buster board, turtles board, slap board, custard board, gypsum panel and gyprock) is a panel made of calcium sulfate dihydrate (), with or without additives, typically extruded between thick sheets of ...
Truss uplift or truss lift is the shrinking of the wood in wooden trusses, causing the bottom-most piece to bow upwards, most notably near the middle. Truss lift is an issue in wood-frame construction where non-load bearing walls meet ceilings, as the truss lifting it pulls the ceiling drywall up. This in turn pulls the angle tape out of the ...
Roof laths span across between the rafters and support the wood shingles. A lath or slat is a thin, narrow strip of straight-grained wood used under roof shingles or tiles, on lath and plaster walls and ceilings to hold plaster, and in lattice and trellis work. [1] Lath has expanded to mean any type of backing material for plaster.
Wall framing in house construction includes the vertical and horizontal members of exterior walls and interior partitions, both of bearing walls and non-bearing walls. . These stick members, referred to as studs, wall plates and lintels (sometimes called headers), serve as a nailing base for all covering material and support the upper floor platforms, which provide the lateral strength along a
A rail repair dutchman is typically a 4–6-inch (100–150 mm) long piece of rail that is cut in advance for the purpose and carried by a section crew. If the gang finds a rail with a chipped or broken end, they remove the connector plates ( fishplates ), cut out the damaged section, replace it with the dutchman, and bolt the connectors back ...