Search results
Results From The WOW.Com Content Network
Feet of pipe (ft) = Volume of mud (bbls) / Capacity (bbls/ft) Capacity calculation is important in oil well control due to the following: Volume of the drillpipe and the drill collars must be pumped to get kill weight mud to the bit during kill operation. It is used to spot pills and plugs at various depths in the wellbore. [26]
The principle of a well kill revolves around the influence of the weight of a fluid column and hence the pressure exerted at the wellbore's bottom. P = h g ρ {\displaystyle P=hg\rho } Where P is the pressure at a specific depth, h, within the column, g is the acceleration of gravity and ρ is the density of the fluid.
Mishandling mud at the surface accounts for many instances of insufficient fluid weight. Such as opening the wrong valve on the pump suction manifold and allowing a tank of lightweight fluid to be pumped; bumping the water valve so more is added than intended; washing off shale shakers; or clean-up operations. All of these can affect mud weight.
Drilling fluids also support portion of drill-string or casing through buoyancy. Suspend in drilling fluid, buoyed by force equal to weight (or density) of mud, so reducing hook load at derrick. Weight that derrick can support limited by mechanical capacity, increase depth so weight of drill-string and casing increase.
In the oil industry, mud weight is the density of the drilling fluid and is normally measured in pounds per gallon (lb/gal) (ppg) or pound cubic feet (pcf) . [1] In the field it is measured using a mud scale or mud balance. Mud can weigh up to 22 or 23 ppg. A gallon of water typically weighs 8.33 pounds (or 7.48 ppg).
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
It claims Ms Bongolan "attempted to resist him, throwing her weight back in a desperate struggle to avoid being thrown to the ground and likely to her death", but Mr Combs "easily overpowered her".
Denser mud is then circulated into the wellbore down the drill string, up the annulus and out through the choke line at the base of the BOP stack through chokes (flow restrictors) until downhole pressure is overcome. Once “kill weight” mud extends from the bottom of the well to the top, the well has been “killed”.