Ads
related to: two stroke weed eater gas mixture
Search results
Results From The WOW.Com Content Network
Animation of a two-stroke engine. A two-stroke (or two-stroke cycle) engine is a type of internal combustion engine that completes a power cycle with two strokes of the piston (one up and one down movement) in one revolution of the crankshaft in contrast to a four-stroke engine which requires four strokes of the piston in two crankshaft revolutions to complete a power cycle.
Unlike a four-stroke engine, the crankcase of which is closed except for its ventilation system, a two-stroke engine uses the crankcase as part of the induction tract, so oil must be mixed with gasoline to be distributed throughout the engine for lubrication. [1] The resultant mix is referred to as premix or petroil. [2]
The two-stroke engines used in most leaf blowers operate by mixing gasoline with oil, and a third of this mixture is not burned, but is emitted as an aerosol exhaust. These pollutants have been linked to cancer, heart disease, and asthma. [10]
The actual gas leaving the pipe during a particular cycle was created two or three cycles earlier. This is why exhaust gas sampling on two stroke engines is done with a special valve right in the exhaust port. The gas exiting the stinger has had too much resident time and mixing with gas from other cycles causing errors in analysis.
The split-single uses a two-stroke cycle (i.e. where every downward stroke produces power) with the following phases: Pistons travel upwards, compressing the fuel-air mixture in both cylinders. A spark plug ignites the mixture (in the right side cylinder in the animation) when the pistons are near the top of the cylinders.
Amount of two-stroke oil injected by the pump depends on the throttle position. A cable from the throttle is connected to the oil pump indicating throttle's position. A tube ensures flow of oil from the reservoir to the oil pump. This system is commonly used for motorcycles as it eliminates the need of pre-mixing fuel and two-stroke oil.
Hot-bulb engine (two-stroke). 1. Hot bulb. 2. Cylinder. 3. Piston. 4. Crankcase Old Swedish hot-bulb engine in action. The hot-bulb engine, also known as a semi-diesel [1] or Akroyd engine, is a type of internal combustion engine in which fuel ignites by coming in contact with a red-hot metal surface inside a bulb, followed by the introduction of air (oxygen) compressed into the hot-bulb ...
Conventionally, a four-stroke (petrol or gasoline) Otto cycle engine is fueled by drawing a mixture of air and fuel into the combustion chamber during the intake stroke. This produces a homogeneous charge: a homogeneous mixture of air and fuel, which is ignited by a spark plug at a predetermined moment near the top of the compression stroke.