When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Centrifugal pump - Wikipedia

   en.wikipedia.org/wiki/Centrifugal_pump

   Centrifugal pumps with an internal suction stage such as water-jet pumps or side-channel pumps are also classified as self-priming pumps. [10] Self-Priming centrifugal pumps were invented in 1935. One of the first companies to market a self-priming centrifugal pump was American Marsh in 1938. [citation needed]

3. Centrifugal pump selection and characteristics - Wikipedia

   en.wikipedia.org/wiki/Centrifugal_pump_selection...

   While centrifugal pumps impart momentum to the fluid by motion of blades, positive displacement pumps transfer fluid by variation in the size of the pump’s chamber. Centrifugal pumps can be of rotor or propeller types, whereas positive displacement pumps may be gear-based, piston-based, diaphragm-based, etc. As a general rule, centrifugal ...

4. Sundyne - Wikipedia

   en.wikipedia.org/wiki/Sundyne

   HMD Pumps in England invents and engineers the world's first magnet drive pump. 1957—Sundstrand develops the first water injection pump for the commercial jet aircraft industry. The pump is designed to boost engine thrust during takeoff. 1962—Sundstrand develops the first Sundyne high-speed centrifugal pump and sells it to Shell Chemical.

5. American Marsh - Wikipedia

   en.wikipedia.org/wiki/American_marsh

   Two steam powered water pumps and an air compressor pre-1915. The "Marsh" portion of the company name came from Elon Marsh, an engineer at the company. In the 1930s they manufactured the TURBO pump. Today the largest pump they market is the 480 Vertical turbine pump. The company is considered a major pump manufacturer and key pump design developer.

6. Grundfos - Wikipedia

   en.wikipedia.org/wiki/Grundfos

   Grundfos (Danish pronunciation: [ˈkʁɔnfʌs]) is the largest pump manufacturer in the world, based in Denmark, with more than 19,000 employees globally. The annual production of more than 16 million pump units, circulator pumps (UP), submersible pumps (SP), and centrifugal pumps (CR).

7. Circulator pump - Wikipedia

   en.wikipedia.org/wiki/Circulator_pump

   This avoids one of the principal challenges faced by the larger, two-part pumps: maintaining a water-tight seal at the point where the pump drive shaft enters the pump body. Small- to medium-sized circulator pumps are usually supported entirely by the pipe flanges that join them to the rest of the hydronic plumbing. Large pumps are usually pad ...