Ads
related to: furnace cycling but not igniting what are the causes of pollution
Search results
Results From The WOW.Com Content Network
The first stage of combustion occurred inside a hot bulb, where the hot gases were forced out into the cylinder. Then, when mixed with additional air, the second stage of combustion took place. During those times, staged combustion was used because it was a convenient method of ignition, and, likely, there was not much concern about air pollution.
A furnace needs no less than two stoves, but may have three. One of the stoves is 'on gas', receiving hot gases from the furnace top and heating the checkerwork inside, whilst the other is 'on blast', receiving cold air from the blowers, heating it and passing it to the blast furnace.
Typically a range of air to fuel ratios exists, outside of which ignition will not occur. These are known as the lower and upper explosive limits. In an internal combustion engine or industrial furnace, the air–fuel ratio is an important measure for anti-pollution and performance-tuning reasons.
The term "hot air engine" specifically excludes any engine performing a thermodynamic cycle in which the working fluid undergoes a phase transition, such as the Rankine cycle. Also excluded are conventional internal combustion engines , in which heat is added to the working fluid by combustion of fuel within the working cylinder.
Induction furnaces do not require an arc, as in an electric arc furnace, or combustion, as in a blast furnace. As a result, the temperature of the charge (the material entered into the furnace for heating, not to be confused with electric charge) is no higher than required to melt it; this can prevent the loss of valuable alloying elements. [5]
A condensing gas furnace includes a sealed combustion area, combustion draft inducer and a secondary heat exchanger. The primary gain in efficiency for a condensing gas furnace, as compared to a mid-efficiency forced-air or forced-draft furnace, is the capture of latent heat from the exhaust gases in the secondary heat exchanger.
“It can cause severe short-lived symptoms, but typically resolves quickly without treatment,” says Pratima Dibba, MD, a board-certified gastroenterologist practicing in New York City.
Extracts heat from the environment, using either the ground or air as the source, via the refrigeration cycle. Requires less energy than electric resistance heating and possibly more efficient than fossil fuel fired furnaces (gas/oil/coal). Air source types may not be suitable for cold climates unless used with backup (secondary) source of heat.