Search results
Results From The WOW.Com Content Network
The scabbard was of black leather with a steel locket and chape. [13] The scabbard was fitted with "Verney's catch" to retain the bayonet when scrambling into and out of ship's boats. From 30 January 1862 the scabbards were redesigned by Colonel Dixon of the Royal Small Arm Factory to include a spring in lieu of Verney's catch, to retain the ...
In 1868 the ordnance board recommended that no more leather sword, or bayonet scabbards be purchased, so after the leather ones were used up, a black Japanned steel scabbard was substituted, along with a new pattern leather frog. It remained in service as a ceremonial weapon until general orders No. 77 dated August 6, 1875 discontinued its use.
The M1910 scabbard was covered in canvas with a leather tip to prevent the blade tip from tearing the material. A wire hook that engaged grommets on the cartridge belt replaced the belt-hanger. The M1910 scabbard was the primary scabbard used during the World War I. Earlier M1905 scabbards were modified by replacing the belt-hanger with a belt ...
An elaborate Celtic scabbard of 1-200 AD, in two colours of bronze 1916 Leather Scabbard for a saddle lever-action rifle of Jack Peters, a ranch hand that worked on the Grant-Kohrs Ranch, in Powell County, Montana. A scabbard is a sheath for holding a sword, dagger, knife, or similar edged weapons.
The Pattern 1907 bayonet was supplied with a simple leather scabbard fitted with a steel top-mount and chape, and usually carried from the belt by a simple frog. The Pattern 1907 bayonet attaches to the SMLE by a boss located below the barrel on the nose of the rifle and a mortise groove on the pommel of the bayonet. [2] [4]
The scabbard was made of steel, hanging from a leather strap, and was 22.7 cm long. A total of 101750 [27] was manufactured by Kongsberg Våpenfabrikk, Husqvarna and Steyr. Bayonet M/1912 was constructed during the development of the "short rifle" that became the M1912 carbine. It was significantly longer than the M/1894, to maintain the "reach ...
Henry V. Allien & Company submitted five pattern swords for the uniform board's consideration, three with straight blades and two with curved, and the Ordnance Department submitted a similar number. The result was that of the ten patterns, one of the Allien swords was adopted, the very one approved by General Kelton.
The No. 4 bayonet was created to replace the current bayonet at the time in service which was the World War I vintage Pattern 1907 bayonet. [2] It was the result of the British search for a new bayonet to replace the Pattern 1907 which began just after World War I which came to the conclusion around the beginning of World War II that the best replacement for the pattern 1907 bayonet would be a ...