Ads
related to: maximum bending radius of cable needed to connect computer to printer
Search results
Results From The WOW.Com Content Network
The minimum bend radius is of particular importance in the handling of fiber-optic cables, which are often used in telecommunications. The minimum bending radius will vary with different cable designs. The manufacturer should specify the minimum radius to which the cable may safely be bent during installation and for the long term.
An IEEE 1284 36-pin female on a circuit board. In the 1970s, Centronics developed the now-familiar printer parallel port that soon became a de facto standard.Centronics had introduced the first successful low-cost seven-wire print head [citation needed], which used a series of solenoids to pull the individual metal pins to strike a ribbon and the paper.
The inner diameter measures 9 μm for single-mode cables, and 50 / 62.5 μm for multi-mode cables. The development of "reduced bend radius" fiber in the mid-2000s, enabled a trend towards smaller cables. Each unit of diameter reduction in a round cable, produces a disproportionate corresponding reduction in the space the cable occupies. [1]
Networking cable is a piece of networking hardware used to connect one network device to other network devices or to connect two or more computers to share devices such as printers or scanners. Different types of network cables, such as coaxial cable , optical fiber cable , and twisted pair cables, are used depending on the network's topology ...
Category 6 and 6A cable must be properly installed and terminated to meet specifications. The cable must not be kinked or bent too tightly; the bend radius should be larger than four times the outer diameter of the cable. [16] The wire pairs must not be untwisted and the outer jacket must not be stripped back more than 13 mm (0.51 in).
Printer cable refers to the cable that carries data between a computer and a printer. There are many different types of cables, for example: Serial: RS-232, EIA-422; Parallel; FireWire; USB; Parallel port printers have been slowly phased out, and are now difficult to find for the most part, being considered as an obsolete legacy port on most ...
As 19-inch equipment has a maximum width of 17 + 1 ⁄ 4 inches (438.15 mm), they can easily be mounted in an ETSI rack by means of an ETSI bracket or adapter plate. In contrast to the 19-inch standards, ETSI also defined the size of the rack enclosure: the four allowed widths are 150, 300, 600, 900 millimetres (5.9, 11.8, 23.6, 35.4 in) and ...
International standard ISO/IEC 11801 Information technology — Generic cabling for customer premises specifies general-purpose telecommunication cabling systems (structured cabling) that are suitable for a wide range of applications (analog and ISDN telephony, various data communication standards, building control systems, factory automation).