Search results
Results From The WOW.Com Content Network
An SSTV repeater is an amateur radio repeater station that relays slow-scan television signals. A typical SSTV repeater is equipped with a HF or VHF transceiver and a computer with a sound card, which serves as a demodulator/modulator of SSTV signals. SSTV repeaters are used by amateur radio operators for exchanging pictures.
A radio repeater is a combination of a radio receiver and a radio transmitter that receives a signal and retransmits it, so that two-way radio signals can cover longer distances. A repeater sited at a high elevation can allow two mobile stations, otherwise out of line-of-sight propagation range of each other, to communicate. [1]
A radio repeater retransmits a radio signal. In telecommunications, a repeater is an electronic device that receives a signal and retransmits it. Repeaters are used to extend transmissions so that the signal can cover longer distances or be received on the other side of an obstruction.
In some repeater systems, the time lag can be significant. The lower tone may cause one or two syllables to be clipped before the receiver audio is unmuted (is heard). This is because receivers are decoding in a chain. The repeater receiver must first sense the carrier signal on the input, then decode the CTCSS tone.
We've talked before about expansion efforts in Texas and Arkansas, at Redstone as well and in Tucson. So supply chain is getting healthier, capacity is being put into place. Demand is there.
WWVB's Colorado location makes the signal weakest on the U.S. east coast, where urban density also produces considerable interference. In 2009, NIST raised the possibility of adding a second time code transmitter, on the east coast, to improve signal reception there and provide a certain amount of robustness to the overall system should weather or other causes render one transmitter site ...
A typical microwave repeater link setup, this one located near Salt Lake City, Utah, USA(removed in 2013) Operation principle. A passive repeater or passive radio link deflection, is a reflective or sometimes refractive panel or other object that assists in closing a radio or microwave link, in places where an obstacle in the signal path blocks any direct, line of sight communication.
An active circuit used for such a purpose is known as a repeater. In a CMOS integrated circuit, the repeater is often a simple inverter. Reducing the delay of a wire by cutting it in half and inserting a repeater is known as repeater insertion. The cost of this procedure is the additional new delay through the repeater itself, plus power cost ...