Ads
related to: car ignition problems
Search results
Results From The WOW.Com Content Network
The ignition switch was designed to remove power from the vehicle's airbags when in the Off or Accessory mode. [11] Therefore, this was a safety hazard: If the switch changed from Run to Accessory and the vehicle was involved in an accident, it would no longer have power to release the airbags, and it would be difficult for the driver to steer ...
Honda Motor (HMC) is recalling some 384,000 vehicles for problems related to the ignition interlock, which could fail and possibly allow the vehicles to roll away even if drivers feel their cars ...
The most famous aftermarket electronic ignition which debuted in 1965, was the Delta Mark 10 capacitive discharge ignition, which was sold assembled or as a kit. The Fiat Dino was the first production car to come standard with EI in 1968, followed by the Jaguar XJ Series 1 [9] in 1971, Chrysler (after a 1971 trial) in 1973 and by Ford and GM in ...
Low-speed pre-ignition (LSPI), also known as stochastic pre-ignition (SPI), [1] is a pre-ignition event that occurs in gasoline vehicle engines when there is a premature ignition of the main fuel charge. [2] LSPI is most common in certain turbocharged direct-injection vehicles operating in low-speed and high-load driving conditions. [3]
Faulty ignition switches in the Cobalts, which cut power to the car while in motion, were eventually linked to many crashes resulting in fatalities, starting with a teenager in 2005 who drove her new Cobalt into a tree. [15] The switch continued to be used in the manufacture of the vehicles even after the problem was known to GM. [16]
The problem of cold starting has been greatly reduced since the introduction of engine starters, which are now commonplace on all modern vehicles.The higher rpm that can be achieved using electric starter motors improves the chance of successful ignition.
The ignition source of a diesel engine is the heat generated by the compression of the air in the cylinder, rather than a spark as in gasoline engines. The dieseling phenomenon occurs not just because the compression ratio is sufficient to cause auto-ignition of the fuel, but also because a hot spot inside the cylinder (spark plug electrode ...
These effects can largely be overcome using electronic ignition systems, where the contact breakers are retrofitted by a magnetic (Hall effect) or optical sensor device. However, because of their simplicity, and since contact breaker points gradually degrade instead of catastrophically failing, they are still used on aircraft engines.