Search results
Results From The WOW.Com Content Network
The main disadvantage with a push feed system is the possibility for a double feed malfunction if the bolt is not fully closed when chambering a round, followed with pulling the bolt back to strip another round from the magazine, resulting in one chambered and one partially chambered round. A double feed in itself is somewhat uncommon as an ...
The Remington model 770 is a magazine fed, bolt action, center-fire rifle. The 770 is available in 243 Win, 270 Win, 7mm-08 Rem, 7mm Rem Mag, 30-06 Sprg, 300 Win Mag, and 308 Win. The standard, factory magazine can hold up to 4 rounds (3 rounds in the magnum version) plus 1 loaded directly into the chamber.
An unusual feature of this rifle is that it uses a tubular magazine in conjunction with a bolt action. Most modern tube-fed firearms typically use a lever action or a pump action, but in the middle of the 20th century, many bolt-action .22's used tubular magazines as the high-capacity magazine of the era. [citation needed]
The SIG Sauer SSG 3000 (Scharfschützengewehr 3000, literally Sharpshooter Rifle 3000) [3] is a bolt-action, magazine fed rifle chambered in 7.62×51mm NATO. It was developed in Germany. It is a common law enforcement sniper rifle in both Europe and the United States.
The Bor is a bullpup-configuration bolt-action magazine-fed sniper rifle. The configuration provides increased accuracy by allowing a barrel length of 680 mm (26.8 in), but minimizes the overall length of 1,038 mm (40.9 in).
Bolt-action rifle .30-06 Springfield United States Stripper clip with internal 5-round magazine. Air Service variant with permanent 20-round box magazine. M1917 Enfield: Bolt-action rifle.30-06 Springfield United States Stripper clip with 5-round internal magazine. Mannlicher M1895: Bolt-action rifle 8×50mmR Mannlicher 8×56mmR 7.92×57mm Mauser
The Japanese Type 11 light machine gun was the only weapon system that used a hopper magazine. This light machine gun was fed by standard 6.5×50mmSR Arisaka stripper clips that were used by riflemen armed with the Type 38 bolt action rifle. The hopper is located on the left side of the receiver and held 6 of the 5-round clips, for a total of ...
The repeating magazine fed rifle features a milled receiver made from special steel, to which a 90° rotating, two-lug cylindrical bolt locks; [1] [4] the M65 also incorporates two additional safety lugs at the rear of the bolt, [4] as well as two vent holes in the bolt body to vent off gases to the side if a primer breaks. [4]