Search results
Results From The WOW.Com Content Network
INT is an assembly language instruction for x86 processors that generates a software interrupt. It takes the interrupt number formatted as a byte value. [1] When written in assembly language, the instruction is written like this: INT X. where X is the software interrupt that should be generated (0-255).
Ralf Brown's Interrupt List (aka RBIL, x86 Interrupt List, MS-DOS Interrupt List or INTER) is a comprehensive list of interrupts, calls, hooks, interfaces, data structures, CMOS settings, memory and port addresses, as well as processor opcodes for x86 machines from the 1981 IBM PC up to 2000 (including many clones), [1] [2] [nb 1] most of it still applying to IBM PC compatibles today.
Will change OperandSize from 16-bit to 32-bit if CS.D=0, or from 32-bit to 16-bit if CS.D=1. 67h: AddressSize override. Will change AddressSize from 16-bit to 32-bit if CS.D=0, or from 32-bit to 16-bit if CS.D=1. The 80386 also introduced the two new segment registers FS and GS as well as the x86 control, debug and test registers.
FLAGS registers can be moved from or to the stack. This is part of the job of saving and restoring CPU context, against a routine such as an interrupt service routine whose changes to registers should not be seen by the calling code. Here are the relevant instructions: The PUSHF and POPF instructions transfer the 16-bit FLAGS register.
In the x86 architecture, interrupts are handled through the Interrupt Dispatch Table (IDT). When a device triggers an interrupt and the interrupt flag (IF) in the FLAGS register is set, the processor's hardware looks for an interrupt handler in the table entry corresponding to the interrupt number to which in turn has been translated from IRQ ...
The descriptors may be either interrupt gates, trap gates or, for 32-bit protected mode only, task gates. Interrupt and trap gates point to a memory location containing code to execute by specifying both a segment (present in either the GDT or LDT) and an offset within that segment. The only difference between trap and interrupt gates is that ...
Furthermore, on a modern x86 system, BIOS calls can only be performed in Real mode, or Virtual 8086 mode. v8086 is not an option in Long mode. This means that a modern operating system, which operates in Protected mode (32 bit), or Long mode (64 bit), would need to switch into real mode and back to call the BIOS - a hugely expensive operation.
For example, hardware timers send interrupts to the CPU at regular intervals. Most operating systems execute a HLT instruction when there is no immediate work to be done, putting the processor into an idle state. In Windows NT, for example, this instruction is run in the "System Idle Process". On x86 processors, the opcode of HLT is 0xF4.