Search results
Results From The WOW.Com Content Network
Chain reactions naturally give rise to reaction rates that grow (or shrink) exponentially, whereas a nuclear power reactor needs to be able to hold the reaction rate reasonably constant. To maintain this control, the chain reaction criticality must have a slow enough time scale to permit intervention by additional effects (e.g., mechanical ...
The mere fact that an assembly is supercritical does not guarantee that it contains any free neutrons at all. At least one neutron is required to "strike" a chain reaction, and if the spontaneous fission rate is sufficiently low it may take a long time (in 235 U reactors, as long as many minutes) before a chance neutron encounter starts a chain reaction even if the reactor is supercritical.
This is then a self-propagating and thus self-sustaining chain reaction. This is the principle for nuclear reactors and atomic bombs. Demonstration of a self-sustaining nuclear chain reaction was accomplished by Enrico Fermi and others, in the successful operation of Chicago Pile-1, the first artificial nuclear reactor, in late 1942.
The average neutron lifetime considering delayed neutrons is approximately 0.1 sec, which makes the chain reaction relatively easy to control over time. The remaining 993 prompt neutrons are released very quickly, approximately 1 μs after the fission event. In steady-state operation, nuclear reactors operate at exact criticality.
Therefore, the reaction will increase slowly, with a long time constant. This is slow enough to allow the reaction to be controlled with electromechanical control systems such as control rods, and accordingly all nuclear reactors are designed to operate in the delayed-criticality regime.
Control rods are partially removed from the core to allow the nuclear chain reaction to start up and increase to the desired power level. Neutron flux can be measured, and is roughly proportional to reaction rate and power level. To increase power output, some control rods are pulled out a small distance for a while.
Controlled polymerization conditions are usually achieved by extending the life-time of the growing polymer chain radical, by keeping it in a dormant state for most of the time (known as the Persistent Radical Effect). Thereby the control agent substantially slows-down the over-all radical polymerisation reaction.
When the control rods are lowered into the core, they absorb neutrons, which thus cannot take part in the chain reaction. On the converse, when the control rods are lifted out of the way, more neutrons strike the fissile uranium-235 or plutonium-239 nuclei in nearby fuel rods, and the chain reaction intensifies.