Ads
related to: sony high level input connector adapter for stereo box for radio station
Search results
Results From The WOW.Com Content Network
Three RCA connectors - yellow for composite video, and white and red for stereo audio RCA connector: Widely used in consumer electronics for audio and video. A single connector must be used for each signal. SCART: Consumer electronics, mostly in Europe. Carries analog stereo sound, along with composite video and/or RGB video.
A Sony D-V500 portable video CD player from 1996. Note that it does not bear the Discman brand. Video CD Discman, later rebranded as VCD Walkman, was a line of portable Video CD players. They were able to output the audio from video CDs as usual, but were also equipped with an additional 3.5mm audio/video-to-RCA connector output. [5] [6] [7]
A phone connector (tip, ring, sleeve) also called an audio jack, phone plug, jack plug, stereo plug, mini-jack, or mini-stereo. This includes the original 6.35 mm (quarter inch) jack and the more recent 3.5 mm (miniature or 1/8 inch) and 2.5 mm (subminiature) jacks, both mono and stereo versions.
As of January 2009, Sony seems to be the only manufacturer proposing this interface. They offer different accessories to connect DMP ready equipment like their Bravia TV or Home Theater receivers to Walkman, iPod, PC or any Bluetooth devices. The connector of this port is Hirose ST60-18P(50).
The RCA connector [3] is a type of electrical connector commonly used to carry audio and video signals. The name RCA derives from the company Radio Corporation of America, which introduced the design in the 1930s. [4] The connector’s male plug and female jack are called RCA plug and RCA jack. It is also called RCA phono connector [5] or phono ...
Balanced and unbalanced circuits can be interfaced by the use of a balun, often through a DI unit (also called a "DI box" or "direct box"). As a last resort a balanced audio line can be fed into an unbalanced input and vice versa as long as the electronic design used for the output stage is known.
Phono input is a set of input jacks, usually mini jacks or RCA connectors, located on the rear panel of a preamp, mixer or amplifier, especially on early radio sets, to which a phonograph or turntable is attached. [1] Modern phono cartridges give a very low level output signal of the order of a few millivolts which the circuitry amplifies and ...
A typical cassette adapter uses a single-sided writing tape head (similar to the recording head on a traditional tape deck) connected to a stereo minijack connector with a cord. The cord is connected to the device's output (or headphones) port and the electrical signal is converted into a magnetic signal by the head.
Ad
related to: sony high level input connector adapter for stereo box for radio station