Search results
Results From The WOW.Com Content Network
PWM output (some devices have an enhanced PWM peripheral which includes a dead-time generator) Input capture that record a time stamp triggered by a signal edge; Analog comparator; 10 or 12-bit A/D converters, with multiplex of up to 16 channels; 12-bit D/A converters; A variety of serial interfaces, including I²C compatible Two-Wire Interface ...
Top: source, bottom: drain, left: gate, right: bulk. Voltages that lead to channel formation are not shown. In field-effect transistors (FETs), depletion mode and enhancement mode are two major transistor types, corresponding to whether the transistor is in an on state or an off state at zero gate–source voltage.
The first FET device to be successfully built was the junction field-effect transistor (JFET). [2] A JFET was first patented by Heinrich Welker in 1945. [4] The static induction transistor (SIT), a type of JFET with a short channel, was invented by Japanese engineers Jun-ichi Nishizawa and Y. Watanabe in 1950.
Figure 1: Basic N-channel JFET common-source circuit (neglecting biasing details). Figure 2: Basic N-channel JFET common-source circuit with source degeneration. In electronics, a common-source amplifier is one of three basic single-stage field-effect transistor (FET) amplifier topologies, typically used as a voltage or transconductance amplifier.
A circuit diagram (or: wiring diagram, electrical diagram, elementary diagram, electronic schematic) is a graphical representation of an electrical circuit. A pictorial circuit diagram uses simple images of components, while a schematic diagram shows the components and interconnections of the circuit using standardized symbolic representations.
The junction field-effect transistor (JFET) is one of the simplest types of field-effect transistor. [1] JFETs are three-terminal semiconductor devices that can be used as electronically controlled switches or resistors , or to build amplifiers .
In the circuit on the figure, a non-linearized VCR design, the voltage-controlled resistor, the LSK489C JFET, is used as a programmable voltage divider. The VGS supply sets the level of the output resistance of the JFET. The drain-to-source resistance of the JFET (R DS) and the drain resistor (R 1) form the voltage-divider network. The output ...
The JFET is externally-powered by the DC voltage V + through a resistor which sets the gain and output impedance. The output audio signal is received though a DC blocking capacitor . An electret microphone is a microphone whose diaphragm forms a capacitor (historically-termed a condenser ) that incorporates an electret .