Search results
Results From The WOW.Com Content Network
A physical extended star topology in which repeaters are replaced with hubs or switches is a type of hybrid network topology and is referred to as a physical hierarchical star topology, although some texts make no distinction between the two topologies. A physical hierarchical star topology can also be referred as a tier-star topology.
Star topology in use in a network. A star network is an implementation of a spoke–hub distribution paradigm in computer networks. In a star network, every host is connected to a central hub. In its simplest form, one central hub acts as a conduit to transmit messages. [1] The star network is one of the most common computer network topologies.
A Tier 1 network is an Internet Protocol (IP) network that can reach every other network on the Internet solely via settlement-free interconnection (also known as settlement-free peering). [1] [2] Tier 1 networks can exchange traffic with other Tier 1 networks without paying any fees for the exchange of traffic in either direction. [3]
Moreover, scalability is another major issue in three-tier DCN. Major problems faced by the three-tier architecture include, scalability, fault tolerance, energy efficiency, and cross-sectional bandwidth. The three-tier architecture uses enterprise-level network devices at the higher layers of topology that are very expensive and power hungry. [5]
[citation needed] In the late 1970s the telecommunications and information technology sector subsequently adopted this distribution topology, dubbing it the star network network topology. "Hubbing" involves "the arrangement of a transportation network as a hub-and-spoke model". [2] Point-to-point (top) vs hub-and-spoke (bottom) networks
ANSI/TIA-568 is a technical standard for commercial building cabling for telecommunications products and services. The title of the standard is Commercial Building Telecommunications Cabling Standard and is published by the Telecommunications Industry Association (TIA), a body accredited by the American National Standards Institute (ANSI).
An early version of StarLAN was developed by Tim Rock and Bill Aranguren at AT&T Information Systems as an experimental system in 1983. [1] The name StarLAN was coined by the IEEE task force based on the fact that it used a star topology from a central hub in contrast to the bus network of the shared cable 10BASE5 and 10BASE2 networks that had been based on ALOHAnet.
The centralized star topology was also already often in use for telephone service cabling, as opposed to the bus topology required by earlier Ethernet standards. Using point-to-point links was less prone to failure and greatly simplified troubleshooting compared to a shared bus .