Search results
Results From The WOW.Com Content Network
In half-wave rectification of a single-phase supply, either the positive or negative half of the AC wave is passed, while the other half is blocked. Because only one half of the input waveform reaches the output, mean voltage is lower. Half-wave rectification requires a single diode in a single-phase supply, or three in a three-phase supply.
(See also: Rectifier § Rectifier voltage drop) However, a semiconductor diode's exponential current–voltage characteristic is really more gradual than this simple on–off action. [ 8 ] Although an exponential function may appear to have a definite " knee " around this threshold when viewed on a linear scale, the knee is an illusion that ...
The characteristics and components of ripple depend on its source: there is single-phase half- and full-wave rectification, and three-phase half- and full-wave rectification. Rectification can be controlled (uses Silicon Controlled Rectifiers (SCRs)) or uncontrolled (uses diodes). There is in addition, active rectification which uses transistors.
Pulsed DC is commonly produced from AC (alternating current) by a half-wave rectifier or a full-wave rectifier. Full wave rectified ac is more commonly known as Rectified AC. PDC has some characteristics of both alternating current (AC) and direct current (DC) waveforms.
A hand-made diode bridge. The silver band on the diodes indicates the cathode side of the diode.. A diode bridge is a bridge rectifier circuit of four diodes that is used in the process of converting alternating current (AC) from the input terminals to direct current (DC, i.e. fixed polarity) on the output terminals.
Whereas normal semiconductor diodes have a roughly fixed voltage drop of around 0.5 to 1 volts, active rectifiers behave as resistances, and can have arbitrarily low voltage drop. Historically, vibrator -driven switches or motor-driven commutators have also been used for mechanical rectifiers and synchronous rectification.
The wildfires in Los Angeles continued to burn mostly out of control, with at least five blazes being fueled by dry conditions and ferocious winds in California.
Such a configuration is called a "half bridge". [4] It acts as an electronic toggle switch, the half bridge is not able to switch polarity of the voltage applied to the load. The half bridge is used in some switched-mode power supplies that use synchronous rectifiers and in switching amplifiers. The half-H bridge type is commonly abbreviated to ...