Ads
related to: drag strut beam system for rv 5th column kit near me
Search results
Results From The WOW.Com Content Network
As such, push-rod suspension systems allow for much greater high-speed stability, much lower levels of body-roll, and a much lower centre of gravity for the vehicle. [7] For pull-rod suspension systems, the only difference is the orientation of the rocker arms. In a push-rod system, the rocker arms are placed at the highest point in the assembly.
Torsion bar suspension inside Leopard 2 Schematic of a front axle highlighted to show torsion bar. A torsion bar suspension, also known as a torsion spring suspension, is any vehicle suspension that uses a torsion bar as its main weight-bearing spring. One end of a long metal bar is attached firmly to the vehicle chassis; the opposite end ...
In 1947 Earle MacPherson patented the MacPherson strut for use on the Chevrolet Cadet. [4] [5] This was the first true strut suspension for cars: the stub axle was rigidly fixed to the strut, thus always keeping the same angle with it, rather than being attached through a swivelling joint as for Stout's Scarab.
Jeg Coughlin Sr. started JEGS Automotive Inc. in 1960 in a garage near downtown Columbus, Ohio because there was no source in the Midwest to obtain high-performance auto parts to modify hot rods. As JEGS became known for their full selection, the "garage" grew into a successful company.
Honda introduced another variation strut set-up, called "dual-axis", which is used in the suspension design of the Civic Type-R. Another variant of the MacPherson strut is the double pivot front suspension, which splits the lower wishbone into two while retaining the standard upright design of the MacPherson strut.
A beam axle, rigid axle, or solid axle is a dependent suspension design in which a set of wheels is connected laterally by a single beam or shaft. Beam axles were once commonly used at the rear wheels of a vehicle, but historically, they have also been used as front axles in four-wheel-drive vehicles.
A multi-link suspension is a type of independent vehicle suspension having three or more control links per wheel. [1] These arms do not have to be of equal length, and may be angled away from their "obvious" direction. It was first introduced in the late 1960s on the Mercedes-Benz C111 [2] and later on their W201 and W124 series. [3] [4]
The Kinetic Dynamic Suspension System was first available as an option on the model year 2004 Lexus GX 470, a sport utility vehicle that was only sold in North America, and based roughly on the 120 Series Land Cruiser Prado. The system was also introduced in similar form on the 2008 Toyota Land Cruiser.