Ads
related to: la hernia discal surgery recovery- 262 Neil Avenue # 430, Columbus, Ohio · Directions · (614) 221-7464
agingcare.com has been visited by 100K+ users in the past month
Search results
Results From The WOW.Com Content Network
The TESSYS method (transforaminal endoscopic surgical system) is a minimally-invasive, endoscopic spinal procedure for the treatment of a herniated disc.It was a further development of the YESS method by the Dutch Dr Thomas Hoogland in the Alpha Klinik in Munich in 1989 and was first called THESSYS (Thomas Hoogland EndoScopic SYStem).
Disc herniation can occur in any disc in the spine, but the two most common forms are lumbar disc herniation and cervical disc herniation. The former is the most common, causing low back pain (lumbago) and often leg pain as well, in which case it is commonly referred to as sciatica .
A laparoscopic hernia repair is when the hiatal hernia is corrected using a covering for the mesh that is used to repair the weakened area. The defect is then measured and the mesh is stapled into place. [6] A benefit of performing Laparoscopic hernia repair is shorter recovery times compared to other methods.
Inguinal hernia repair with mesh diagram Laparoscopic hernia repair with mesh. Surgery is recommended for some types of hernias to prevent complications such as obstruction of the bowel or strangulation of the tissue, although umbilical hernias and hiatus hernias may be watched, or are treated with medication. [34]
The first differentiating factor in hernia repair is whether the surgery is done open, or laparoscopically. Open hernia repair is when an incision is made in the skin directly over the hernia. Laparoscopic hernia repair is when minimally invasive cameras and equipment are used and the hernia is repaired with only small incisions adjacent to the ...
IDET (Intradiscal Electrothermal Annuloplasty) [1] is a recently developed minimally invasive form of annuloplasty consisting of the insertion of a hollow needle into the affected disc. Through this needle, a heating wire is passed. Once the wire has reached the disc, it is heated to 90 °C for approximately fifteen minutes.