Search results
Results From The WOW.Com Content Network
The voltage of the power outlet is usually near 12 V DC, and may be elevated between 13.5 V to 15 V while the engine is running. On trucks , the voltage of the power outlet may be near 24 V DC. The 12 V power circuit is protected by a car fuse , often rated at 10 to 20 amperes, which provides 120 to 240 watts of power.
Ground for pin 9 [a] ISO 11446:2004 specifies a 13-pole electrical connector between towing and towed vehicles with 12 volt electrical system . It was developed in 1987 by Erich Jaeger [ 1 ] to replace older 7-pin plugs.
Pin A is for activation of so-called Blackout Mode. It turns off all the lights except convoy lighting if it is active. The lighting inside the vehicle shall also be extinguished if it is not specifically shaded. Pin C is for Convoy Lamps, which is the special convoy lighting, corresponding to the tail lights, to be used while driving in the dark.
Trucks usually have a 24 V supply using two 12 V automotive batteries in series: it is therefore possible to jump-start a vehicle with a 12 V electrical system using only one of the two batteries. [11] Vintage cars may have 6-volt electrical systems, or may connect the positive terminal of the battery to the chassis.
Flat 5-pin connector (Towing vehicle side) This contact is not as common, but is compatible with the 4-pin connector in the way that a towing vehicle with this connector can be connected to a trailer with the 4-pin flat plug. The extra connection is often used to block the surge brakes when reversing with the trailer. #
Here are 12 things you should never plug into a power strip. Extension cords in Power Strip. 1. Extension Cords. ... Although they run at a lower wattage (usually 200-300 watts), ...
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
7-pin ISO 1724 trailer connector type 12N (Towing vehicle side). This connector uses a mix of pin and socket terminals. Physical design according to standard ISO 1724. [4] [8] The 7-pin connector uses all 7 pins on newer trailers according to the ISO standard. [9] [10] On older trailers there's sometimes a 5-wire setup using a 7-pin connector.