Search results
Results From The WOW.Com Content Network
Aug 15, 2015. #2. If this is a small scissor with 4- 6 volt deep cycle batteries the charger should start at around 25-30 amps and finish at around 5-7 amps if the batteries are in good condition. But the finish voltage is more important at the end of charge, you should see 30+ volts at the end just before the charger shuts off (2.5 VPC).
Runs like batteries are down, up, fwd, rev. Low voltage on display at both upper and lower controls. No other code. Bypassed contactor to eliminate possible v loss. No difference. Batteries all load test individually good. 24.8V at batteries, 24.8 at key switch & lower circuit breaker.
looking for some diagnostic help on a genie scissor lift with a LL code . Level sensor seems to be ok . Bubble is in the center position . All wiring appears to be plugged in and making contact . Lift goes up a few feet then the alarm goes off and stop moving. Looking for a direction.
Ellensburg Washington. Oct 13, 2022. #1. I have a 1999 GS-2646 scissor lift that has worked flawlessly for many years. A few months back I used it to go up to my rafters brought it back down and turned it off with the platform estop. I pulled the estop a few minutes later and nothing. The LED display does not work and nothing operated (almost ...
If it's in the low range, try adjusting the relief valve up a bit by removing the cap on lift relief valve cartridge (C in illustration) and turn adjuster inside cartridge CW one turn. Test lift pressure again and see if pressure is now higher. If it's higher, try operating lift with your two workers now. You can adjust that relief up to 3700 ...
Mar 4, 2024. #1. I'm having issues determining if my batteries are bad in my Genie scissor lift, model GS2646 with Trojan T105 batteries. The batteries are mixed batteries from 2022. Fully charged, the batteries read around 26 volts as a full pack, individually about 6.5 volts a piece. When a function is used, the voltage drops to around 22-23 ...
We are having a somewhat random code 18 flash sometimes that keeps the machine from doing anything other than beeping. Typical case is the lift is resting in the down position from its previous use and we pull the e-stop and get 18 code and warning beep. Again the lift is in the down position and the pothole guards are not deployed.
99% of the time it is in the curly-Q pigtail at the upper controls that cause the 02 fault code. 02 is an interruption in communication between upper and lower controls. One or both of two wires of the five wires in the cable are at life's end and causing this interruption. There are two 12v positive wires (red and black) one Ground wire (white ...
Tested pressure at test port at about 2400lb. On the valve block turned system relief valve and lift relief valve all the way in (about 3 turns) and pressure only increased to about 2600lb-2700lb. Still will not lift two people. Book said to set at 1800 to 3700. Took apart the adjustable relief valves and found no noticeable problems.
Location. USA. Yesterday at 5:58 PM. #1. I have a Genie scissor lift where no functions work. I have good voltage coming from my batteries and into the motor controller and out to the rest of the system. Whether the lift is in platform or ground mode, when I hit the "up" switch I get an "A5" code, (Which I believe is the software config.)