Ads
related to: jasper 390 big block dyno heads
Search results
Results From The WOW.Com Content Network
The Chrysler B and RB engines are a series of big-block V8 gasoline engines introduced in 1958 to replace the Chrysler FirePower (first generation Hemi) engines. The B and RB engines are often referred to as "wedge" engines because they use wedge-shaped combustion chambers; this differentiates them from Chrysler's 426 Hemi big block engines that are typically referred to as "Hemi" or "426 Hemi ...
The Chevrolet big-block engine is a series of large-displacement, naturally-aspirated, 90°, overhead valve, gasoline-powered, V8 engines that was developed and have been produced by the Chevrolet Division of General Motors from the late 1950s until present. They have powered countless General Motors products, not just Chevrolets, and have been ...
The head used during this time was the so-called "rectangle port", named after its exhaust port shape. The 290 heads use smaller valves, 1.787 in (45.4 mm) intake and 1.406 in (35.7 mm) exhaust, corresponding with its small bore. The 343 and the AMX 390 use the same larger valve heads, 2.025 in (51.4 mm) intake and 1.625 in (41.3 mm) exhaust.
Cylinder block material: Cast iron: Cylinder head material: Cast iron: Valvetrain: Cam-in-block 2 (B-Series) or 4 (ISB, QSB) valves/cylinder: Compression ratio: 17.2:1, 17.3:1, 17.5:1, 19:1: Combustion; Turbocharger: Holset Engineering (variable) Fuel system: Common rail high pressure direct injection, symmetrical combustion chamber with 7-hole ...
The top-oiler block sent oil to the top center first, the side-oiler block sent oil along a passage located on the lower side of the block first. All FE and FT engines have a bore spacing of 4.630 in (117.6 mm), and a deck height (distance from crank center to top of block) of 10.170 in (258.3 mm).
The big-block engines initially used a forged crankshaft with a stroke of 3.975" for the 1965-1967 425 and 400 CID versions; starting in 1968, both the 400 cu in (6.6 L) and the 455 cu in (7.5 L) big blocks used a stroke of 4.25 in (108 mm), with crankshaft material changed to cast iron except in a few rare cases.
These engines were based on the Hemi engines, using the same blocks and crankshaft parts, but completely different cylinder heads, pushrods, exhaust manifolds and pistons. They were called Polyspheric or Poly engines, because they featured polyspherical-shaped (meaning "more than one sphere") combustion chambers. These combustion chambers were ...
The standard head seen on an L78 400 Pontiac was the low compression 6x8 head, while the 6x4 head seen on the W72 had hardened valve seats for a higher RPM operating range, improved air flow, and higher compression. These heads can be distinguished from 6x8 heads through a small stamped "4" on the top of the front boss.