When.com Web Search

  1. Ads

    related to: vented vs unvented crawl space insulation

Search results

  1. Results From The WOW.Com Content Network
  2. Crawl space - Wikipedia

    en.wikipedia.org/wiki/Crawl_space

    A crawl space or crawlspace is an unoccupied, unfinished, narrow space within a building, between the ground and the first (or ground) floor. The crawl space is so named because there is typically only enough room to crawl rather than stand; anything larger than about 1 to 1.5 metres (3 ft 3 in to 4 ft 11 in) and beneath the ground floor would ...

  3. Attic - Wikipedia

    en.wikipedia.org/wiki/Attic

    Louvered attic vent in a gable. Modern building codes permit both vented and unvented attics in all climates, if a building is otherwise correctly constructed. [5] However, unoccupied attics should usually be ventilated [6] to reduce the accumulation of heat and moisture that contribute to mold growth and decay of wood rafters and ceiling ...

  4. Building insulation - Wikipedia

    en.wikipedia.org/wiki/Building_insulation

    Mineral wool insulation A semi-detached house with one half of the facade in the original state and the other half after insulation with polystyrene Old brick houses in Sosnowiec, Poland, insulated with polystyrene A single-family house in Bielsko-Biała, Poland, during the implementation of thermal insulation A historic building in Kuźnia Raciborska, Poland, during the implementation of ...

  5. Radiant barrier - Wikipedia

    en.wikipedia.org/wiki/Radiant_barrier

    Radiant barrier may be used as a vented skin around the exterior of a wall. [10] Furring strips are applied to the sheathing to create a vented air space between the radiant barrier and the siding, and vents are used at the top and bottom to allow convective heat to rise naturally to the attic.

  6. Duct (flow) - Wikipedia

    en.wikipedia.org/wiki/Duct_(flow)

    For insulation purposes, metal ducts are typically lined with faced fiberglass blankets (duct liner) or wrapped externally with fiberglass blankets (duct wrap). When necessary, a double walled duct is used. This will usually have an inner perforated liner, then a 1–2" (2.5-5 cm) layer of fiberglass insulation contained inside an outer solid pipe.

  7. Drain-waste-vent system - Wikipedia

    en.wikipedia.org/wiki/Drain-waste-vent_system

    In the U.S., every plumbing fixture must also be coupled to the system's vent piping. [1] Without a vent, negative pressure can slow the flow of water leaving the system, resulting in clogs, or cause siphonage to empty a trap. The high point of the vent system (the top of its "soil stack") must be open to the exterior at atmospheric pressure.