Search results
Results From The WOW.Com Content Network
The California Bearing Ratio (CBR) is a measure of the strength of the subgrade of a road or other paved area, and of the materials used in its construction. The ratio is measured using a standardized penetration test first developed by the California Division of Highways for highway engineering . [ 1 ]
3 x Oedometers; 3 x Cells, either 50mm or 63.5mm, or 75mm; 3 x Dial gauges, either analogue, or digital; 1 x Weight set; The consolidation cell is the part of the oedometer that holds the soil sample during a test. At the centre of the consolidation cell is a sample ring where the soil sample is held.
The test uses a thick-walled sampling tube, with an outside diameter of 5.01 cm (2 in) and an inside diameter of 3.5 cm (1.375 in), and a length of at least 60 cm (24 in). The sampling tube is driven into the ground at the bottom of a borehole by blows from a hammer with a mass of 63.5 kg (140 lb) falling a distance of 75 cm (30 in). The sample ...
Many other agencies have adopted the California pavement design method, and specify R-Value testing for subgrade soils and road aggregates. The test method states: The R-value of a material is determined when the material is in a state of saturation such that water will be exuded from the compacted test specimen when a 16.8 kN load (2.07 MPa ...
In this report the CBR-method (California Bearing Ratio) is primarily referred to. The so-called CBR-value represents the ratio of the percentage of the loads required to press a punch of certain dimensions first into a well compacted sample of soil and then into a standard sample of compacted gravels, to a depth of 0.1 inch.
The bearing capacity of soil is the maximum average contact pressure between the foundation and the soil which should not produce shear failure in the soil. Ultimate bearing capacity is the theoretical maximum pressure which can be supported without failure; allowable bearing capacity is the ultimate bearing capacity divided by a factor of ...
The result of a cone penetration test: resistance and friction on the left, friction ratio (%) on the right. The early applications of CPT mainly determined the logistics of soil geotechnical property of bearing capacity. The original cone penetrometers involved simple mechanical measurements of the total penetration resistance to pushing a ...
Triaxial apparatus with sample attached ready for testing. In materials science, a triaxial shear test is a common method to measure the mechanical properties of many deformable solids, especially soil (e.g., sand, clay) and rock, and other granular materials or powders.