When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Constant-velocity joint - Wikipedia

   en.wikipedia.org/wiki/Constant-velocity_joint

   A Rzeppa-type CV joint. A constant-velocity joint (also called a CV joint and homokinetic joint) is a mechanical coupling which allows the shafts to rotate freely (without an appreciable increase in friction or backlash) and compensates for the angle between the two shafts, within a certain range, to maintain the same velocity.

3. Axle - Wikipedia

   en.wikipedia.org/wiki/Axle

   The drive axle is a split axle with a differential and universal joints between the two half axles. Each half axle connects to the wheel by use of a constant velocity (CV) joint which allows the wheel assembly to move freely vertically as well as to pivot when making turns.

4. Continuously variable transmission - Wikipedia

   en.wikipedia.org/wiki/Continuously_variable...

   The most common type of CVT uses a V-belt which runs between two variable-diameter pulleys. [2] The pulleys consist of two cone-shaped halves that move together and apart. The V-belt runs between these two halves, so the effective diameter of the pulley is dependent on the distance between the two halves of the pull

5. Clutch delay valve - Wikipedia

   en.wikipedia.org/wiki/Clutch_delay_valve

   Clutch delay valves operate on the principle that engagement only needs to occur at a certain rate to be efficient, and that engaging the clutch too quickly can cause damage to parts such as the transmission, differential, half shafts, axles, and CV joints. [1]

6. Dana 60 - Wikipedia

   en.wikipedia.org/wiki/Dana_60

   The housing material is Gray iron in early axles and Ductile iron in later axles. GM and Ford Dana 60 axles utilize locking hubs. Dodge Dana 60 axles utilized locking hubs until 1994 when a Center Axle Disconnect (CAD) system was adopted. However, model year 2002 Rams phased out the CAD system leaving some 2002 Dana 60 axles permanently locked in.

7. Drive shaft - Wikipedia

   en.wikipedia.org/wiki/Drive_shaft

   The transmission and final drive for the front axle are combined into one housing alongside the engine, and a single drive shaft runs the length of the car to the rear axle. This is a favoured design where the torque is biased to the front wheels to give car-like handling, or where the maker wishes to produce both four-wheel drive and front ...