When.com Web Search

  1. Ads

    related to: 3 4 inside diameter hose holder for sink

Search results

  1. Results From The WOW.Com Content Network
  2. Garden hose - Wikipedia

    en.wikipedia.org/wiki/Garden_hose

    34-14NPSH designates female hose ends that mate a hose to a tapered pipe thread without a spigot. The US standard was defined by NFPA 1963, "Standard for Fire Hose Connections", [ 2 ] then later by ANSI-ASME B1.20.7, [ 3 ] which specifies 1 + 1 ⁄ 16 inches (27 mm) diameter straight (non-tapered) thread with a pitch of 11.5 threads per ...

  3. Tap (valve) - Wikipedia

    en.wikipedia.org/wiki/Tap_(valve)

    A fibre washer (which expands when wet, aiding the seal) is used between the connector and the tap tail. Tap tails are normally 1 ⁄ 2 " or 12 mm in diameter for sinks and 34 " or 19 mm for baths, although continental Europe sometimes uses a 3 ⁄ 8 " (still imperial) size.

  4. Emergency eyewash and safety shower station - Wikipedia

    en.wikipedia.org/wiki/Emergency_eyewash_and...

    It should be no more than 69 in (180 cm) above the surface floor the user is standing on (Section 4.2). At 60 in (150 cm) above the floor, the water pattern should be 20 in (51 cm) in diameter (Section 4.1.4). If shower enclosure is provided. It should provide 34" in diameter of unobstructed space (86.4 cm) (Section 4.3).

  5. Fire hose - Wikipedia

    en.wikipedia.org/wiki/Fire_hose

    Attack hose is a fabric-covered, flexible hose used to bring water from the fire pumper to the nozzle. This hose ranges in nominal inside diameter from 1.5 to 3 in (38 to 76 mm) and is designed to operate at pressures up to about 400 psi (2,760 kPa). The standard length is 50 ft (15.24 m). [12] Supply and relay hoses

  6. Hose coupling - Wikipedia

    en.wikipedia.org/wiki/Hose_coupling

    Hose link is a 1/4-turn bayonet-mount garden hose connection, which uses an o-ring to o-ring seal. It was designed by Hoselink, Pty, Ltd., Australia, [24] and patented in 1998. [25] It is popular in Australia, with limited distribution in the UK and the US, where it is distributed by Dayco Products, Inc.

  7. Drain-waste-vent system - Wikipedia

    en.wikipedia.org/wiki/Drain-waste-vent_system

    All DWV systems require various sized fittings and pipes which are measured by their internal diameter of both the pipes and the fittings which, and in most cases are Schedule 40 PVC wye's, tee's, elbows ranging from 90 degrees to 22.5 degrees for both inside diameter fitment (street) as well as outer diameter fitment (hub), repair and slip ...

  1. Ads

    related to: 3 4 inside diameter hose holder for sink