Ads
related to: buick camaro 3.8 v6
Search results
Results From The WOW.Com Content Network
The Buick V6 is an OHV V6 engine developed by the Buick division of General Motors and first introduced in 1962. The engine was originally 198 cu in (3.2 L) and was marketed as the Fireball engine.
This was so named because it began with Chevrolet's V8 engines. Chevrolet big-block V8s; Chevrolet small-block V8s; GM Vortec 4300 90° V6; GM Iron Duke RWD inline 4 (early RWD Variants, later versions may use a FWD pattern, and have two possible starter locations)
1977–2013 Chevrolet 90° V6 engine (derived from the Chevrolet Small-Block" V8; now marketed as GM Vortec V6 or Vortec 4300 or EcoTec3 V6) 1979–2010 Chevrolet 60-Degree V6; 1994–2005 Opel 54-Degree L81 V6 (used in the Saturn Vue, Cadillac Catera and Saturn L series) 1995–present Suzuki H (used in several models built for GM by Suzuki)
Unlike most of the prior years, the engine choices were simplified considerably; each year, on both the Camaro and the Firebird, there was only one V6 and one V8 available. For 1993 to 1995, the V6 was the 3.4 L (208 cu in) 60° ; 1996–2002 cars received the 3.8L (231 cu in) 3800 Series II V6. 1993–1997 V8 cars shipped with the 5.7L (350 cu ...
Additionally, the intermediate Chevrolet Malibu and Monte Carlo also used the 229 cu in (3.8 L) as a replacement for both the 200 cu in (3.3 L) V6 and the 231 cu in (3.8 L) Buick V6. Checker Motors Corporation also used this engine starting with its 1980 A11 Taxi and A12 Marathon sedans. Both the Buick V6 and the 229 cu in (3.8 L) Chevrolet V6 ...
In 1986 model, the LeSabre featured the 3.0 liter (181 cubic-inch) V6 as standard, [citation needed] with most models from 1986 until 2005 using Buick's 3.8 liter (231 cubic-inch) V6 engine, developing 150 hp (112 kW). Beginning in 1988 the engine was redeveloped to include a balance shaft, with 165 hp (123 kW).
The fourth-generation Chevrolet Camaro is a pony car that was produced by American automobile manufacturer General Motors for the 1993 through 2002 model years. It was introduced on an updated F-body platform but retained the same characteristic since the first-generation's introduction back in 1967: two doors, coupe or convertible bodystyles, rear-wheel drive, and a choice of 6-cylinder and ...
The High Value engine family from General Motors is a group of cam-in-block or overhead valve V6 engines.These engines feature cast iron blocks and aluminum heads, and use the same 60° vee bank as the 60° V6 family they are based on, but the new 99 mm (3.90 in) bore required offsetting the bores by 1.5 mm (0.059 in) away from the engine center line.