Search results
Results From The WOW.Com Content Network
The K Factor also helps calculate the peak-to-daily ratio of traffic. K30 helps maintain a healthy volume to capacity ratio. [3] K50 and K100 will sometimes be seen. K50 and K100 will not use the 30th highest hourly traffic volumes but the 50th or 100th highest hourly traffic volume when calculating the K factor.
PO gpm = pump output in gpm (gallons per minute) 1 gallon = 0.0238095238 barrels; ID 2 = inside diameter of the wellbore or casing, squared; OD 2 = outside diameter of the drill pipe or tubing, squared; 1029.4 = A conversion factor constant used to calculate the volume between the outside of a tube within the inside of another tube, using barrels.
The area required to calculate the volumetric flow rate is real or imaginary, flat or curved, either as a cross-sectional area or a surface. The vector area is a combination of the magnitude of the area through which the volume passes through, A , and a unit vector normal to the area, n ^ {\displaystyle {\hat {\mathbf {n} }}} .
Note that the m³ gas conversion factor takes into account a difference in the standard temperature base for measurement of gas volumes in metric and imperial units. The standard temperature for metric measurement is 15 degrees Celsius (i.e. 59 degrees Fahrenheit) while for English measurement the standard temperature is 60 °F.
Comparative passenger capacity per hour of various modes of transport. The corridor capacity in the passenger transport field refers to the maximum number of people which can be safely and comfortably transported per unit of time over a certain way with a defined width. The corridor capacity does not measure the number of vehicles which can be ...
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property.
In hydrology, discharge is the volumetric flow rate (volume per time, in units of m 3 /h or ft 3 /h) of a stream. It equals the product of average flow velocity (with dimension of length per time, in m/h or ft/h) and the cross-sectional area (in m 2 or ft 2). [1] It includes any suspended solids (e.g. sediment), dissolved chemicals like CaCO
Notwithstanding these formulas it is widely known that reducing headway increases risk of collision in standard private automobile settings and is often referred to as tailgating. 2) metro system, per line: 40 km/h (~11 m/s) speeds, 1000 passengers, 100 meter vehicle length, 0.5 m/s^2 braking, 2 second reaction time, brick-wall stop, k ...