Search results
Results From The WOW.Com Content Network
EtherChannel between a switch and a server. EtherChannel is a port link aggregation technology or port-channel architecture used primarily on Cisco switches.It allows grouping of several physical Ethernet links to create one logical Ethernet link for the purpose of providing fault-tolerance and high-speed links between switches, routers and servers.
A limitation of Port Aggregation Protocol is that all the physical ports in the aggregation group must reside on the same switch. Cisco's 6500 and the 4500E platforms, remove this limitation using Virtual Switching System (VSS), [1] which allows port channels to be split between two chassis. PAgP is not supported in Cisco Nexus Switches.
A switch virtual interface (SVI) represents a logical layer-3 interface on a switch. VLANs divide broadcast domains in a LAN environment. Whenever hosts in one VLAN need to communicate with hosts in another VLAN, the traffic must be routed between them. This is known as inter-VLAN routing.
Some switches do not implement the 802.1AX standard but support static configuration of link aggregation. Therefore, link aggregation between similarly statically configured switches may work but will fail between a statically configured switch and a device that is configured for LACP.
Once the switches have been assigned a bridge ID and the protocol has chosen the root bridge switch, the best path to the root bridge is calculated based on port cost, path cost and port priority. [ 6 ] : 506 Ultimately STP calculates the path cost on the basis of the bandwidth of a link, however links between switches may have the same bandwidth.
To do this, VTP carries VLAN information to all the switches in a VTP domain. VTP advertisements can be sent over 802.1Q, and ISL trunks. VTP is available on most of the Cisco Catalyst Family products. Using VTP, each Catalyst Family Switch advertises the following on its trunk ports: Management domain; Configuration revision number
The inside of a Cisco 1900-series switch. Catalyst is the brand for a variety of network switches, wireless controllers, and wireless access points sold by Cisco Systems.While commonly associated with Ethernet switches, a number of different types of network interfaces have been available throughout the history of the brand.
The port will not send out DTP frames or be affected by any incoming DTP frames. If you want to set a trunk between two switches when DTP is disabled, you must manually configure trunking using the (switchport mode trunk) command on both sides. The configured switch port mode setting is referred to as the port's trunking administrative mode.