Ads
related to: 1000 watt 10 inch subwoofer 8 ohm
Search results
Results From The WOW.Com Content Network
American EIA standard RS-299A specifies that (or DCR) should be at least 80% of the rated driver impedance, so an 8-ohm rated driver should have a DC resistance of at least 6.4 ohms, and a 4-ohm unit should measure 3.2 ohms minimum. This standard is voluntary, and many 8-ohm drivers have resistances of ≈5.5 ohms, and proportionally lower for ...
The Original 2–12 Vintage is 100 watts, whereas the 6–10 and the 1–15 are only 50 watts The original Classic was a 50 watt amp and two 12-inch speakers and a spring reverb, with two preamps for "clean" and "distortion" channels.
600 watt transformers are widely available for contractors needing high power loudspeakers in constant-voltage installations. [12] Special-purpose transformers capable of handling 1250 watts down as low as 50 Hz are available. [4] One problem with high power, high current transformers is that fewer can be used on a single constant-voltage line.
Line outputs usually present a source impedance of from 100 to 600 ohms. The voltage can reach 2 volts peak-to-peak with levels referenced to −10 dBV (300 mV) at 10 kΩ. The frequency response of most modern equipment is advertised as at least 20 Hz to 20 kHz, which corresponds to the range of human hearing. Line outputs are intended to drive ...
Subwoofers use speaker drivers typically between 8-inch (20 cm) and 21-inch (53 cm) in diameter. Some uncommon subwoofers use larger drivers, and single prototype subwoofers as large as 60-inch (152 cm) have been fabricated. [38] On the smaller end of the spectrum, subwoofer drivers as small as 4-inch (10 cm) may be used.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!