Ad
related to: countertop mitered edge detail pictures for walls and ceiling patterns pdf
Search results
Results From The WOW.Com Content Network
Mason's mitre in a kitchen countertop. A mason's mitre is a type of mitre joint, traditionally used in stonework or masonry but commonly seen in kitchen countertops.In a mason's mitre, the two elements being joined meet as for a butt joint but a small section of one member is removed creating a socket to receive the end of the other.
When installed in a kitchen on standard (U.S) wall-mounted base unit cabinets, countertops are typically about 25–26 inches (640–660 millimetres) from front to back and are designed with a slight overhang on the front (leading) edge. This allows for a convenient reach to objects at the back of the countertop while protecting the base ...
There are several types of butt joint based on the orientation of the pieces being joined. These include the T-butt, end-to-end butt, Miter butt and edge-to-edge butt. The T-butt joint is a very simple joint to construct. Members are simply docked (cut off) at a right angle and at the required length.
90º miter joint (pieces ready to be joined) Miter joint of two pipes A miter joint (mitre in British English) is a joint made by cutting each of two parts to be joined, across the main surface, usually at a 45° angle, to form a corner, usually to form a 90° angle, though it can comprise any angle greater than 0 degrees.
A birds-mouth joint in a rafter, set upon a double top plate. Shown are the two cuts of the joint: the seat cut and the heel cut. In light frame construction, a birdsmouth joint or bird's beak cut is a woodworking joint that is generally used to connect a roof rafter to the top plate of a supporting wall. [1]
In machining a chamfer is a slope cut at any right-angled edge of a workpiece, e.g. holes; the ends of rods, bolts, and pins; the corners of the long-edges of plates; any other place where two surfaces meet at a sharp angle. Chamfering eases assembly, e.g. the insertion of bolts into holes, or nuts.
A building's surface detailing, inside and outside, often includes decorative moulding, and these often contain ogee-shaped profiles—consisting (from low to high) of a concave arc flowing into a convex arc, with vertical ends; if the lower curve is convex and higher one concave, this is known as a Roman ogee, although frequently the terms are used interchangeably and for a variety of other ...
Tin ceiling in a private music room, Queensland, Australia, 1906. Tin ceilings were traditionally painted white to give the appearance of hand-carved or molded plaster. They were incorporated into residential living rooms and parlors as well as schools, hospitals and commercial businesses where painted tin was often used as wainscoting.