Search results
Results From The WOW.Com Content Network
A hemispherical head ("hemi-head") gives an efficient combustion chamber with minimal heat loss to the head, and allows for two large valves.However, a hemi-head usually allows no more than two valves per cylinder due to the difficulty in arranging the valve gear for four valves at diverging angles, and these large valves are necessarily heavier than those in a multi-valve engine of similar ...
The Hemi-6 is a pushrod O.H.V. (overhead valve engine), with combustion chambers comprising about 35% of the top of the globe. This creates what is known as a low hemispherical shaped chamber. In this way, the "Hemi" moniker was used for the same kind of marketing cachet as Chrysler's 1950s-1970s Hemi V8 engines.
The Ford CVH engine is a straight-four automobile engine produced by the Ford Motor Company.The engine's name is an acronym for either Compound Valve-angle Hemispherical or Canted Valve Hemispherical, where "Hemispherical" describes the shape of the combustion chamber.
Considering the definition of combustion chamber used for internal combustion engines, the equivalent part of a steam engine would be the firebox, since this is where the fuel is burned. [citation needed] However, in the context of a steam engine, the term "combustion chamber" has also been used for a specific area between the firebox and the ...
It is similar in concept to the hemi engine, both in design and purpose, but a hemispherical cylinder head is limited to only two valves without the use of a more complex sub-rocker assembly. The four-valve penta engine design was invented by Peugeot of France, [ citation needed ] to be first used in the 1911 Indianapolis 500 race.
The cylinder head has four hemispherical combustion chambers, each with two valves having an included angle of slightly over 73°, with the exhaust valves being inclined from the horizontal about 4° more than the intakes. The valves are made of nimonic steel, and have double valve springs. The camshafts are hollow, and run in five bearings each.
The 90 degree V8 engine has a cast iron block, a short, stiff, dynamically balanced crankshaft carried on five bearings, light-alloy heads [3] with part-hemispherical combustion chambers, and two push-rod operated overhead valves per cylinder operated by a single chain-driven camshaft positioned centrally high up in the vee. [13]
The unusual depth of the engine's cylinder head was dictated by the desire to make room for two generously-sized valves, whilst not excessively restricting the flow of gases into and out of the hemispherical combustion chambers. To satisfy these two conditions, a relatively wide angle between the valves was initially chosen, with quite long ...