Search results
Results From The WOW.Com Content Network
With a local declination of 14°E, a true bearing (i.e. obtained from a map) of 54° is converted to a magnetic bearing (for use in the field) by subtracting declination: 54° – 14° = 40°. If the local declination was 14°W (−14°), it is again subtracted from the true bearing to obtain a magnetic bearing: 54°- (−14°) = 68°.
A standard Brunton compass, used commonly by geologists and surveyors to obtain a bearing in the field. In navigation, bearing or azimuth is the horizontal angle between the direction of an object and north or another object. The angle value can be specified in various angular units, such as degrees, mils, or grad. More specifically:
Each of the 60 zones uses a transverse Mercator projection that can map a region of large north-south extent with low distortion. By using narrow zones of 6° of longitude (up to 668 km) in width, and reducing the scale factor along the central meridian to 0.9996 (a reduction of 1:2500), the amount of distortion is held below 1 part in 1,000 ...
On a Mercator projection map, any rhumb line is a straight line; a rhumb line can be drawn on such a map between any two points on Earth without going off the edge of the map. But theoretically a loxodrome can extend beyond the right edge of the map, where it then continues at the left edge with the same slope (assuming that the map covers ...
A visual fix can be made by using any sighting device with a bearing indicator. Two or more objects of known position are sighted, and the bearings recorded. Bearing lines are then plotted on a chart through the locations of the sighted items. The intersection of these lines is the current position of the vessel.
A bearing compass, is a nautical instrument used to determine the bearing of observed objects. (Bearing: angle formed by the north and the visual to a certain object in the sea or ashore). Used in navigation to determine the angle between the direction of an object and the magnetic north or, indirectly relative to another reference point.
The projection found on these maps, dating to 1511, was stated by John Snyder in 1987 to be the same projection as Mercator's. [6] However, given the geometry of a sundial, these maps may well have been based on the similar central cylindrical projection, a limiting case of the gnomonic projection, which is the basis for a sundial. Snyder ...
Local attraction at a place can be detected by observing bearings from both ends of the line in the area. If fore bearing and back bearing of a line differ exactly by 180°, there is no local attraction at either station. But if this difference is not equal to 180°, then local attraction exists there either at one or both ends of the line. [3]