Ads
related to: adjusting qa1 coil over shocks specifications chart
Search results
Results From The WOW.Com Content Network
The hydraulic shock absorbers used on the rear suspensions of motorcycles are essentially the same as those used in other vehicle applications. Motorcycle shocks do differ slightly in that they nearly always use a coil-over spring. In other words, the spring for the rear suspension is a coil spring that is installed over, or around, the shock.
Full coilovers are matched up with a shock absorber from the factory, while with slip-on coilovers, the dampers and springs are bought separately and then assembled. [4] There are a large number of companies who make aftermarket coilovers for vehicles, many of which allow the customer to adjust various settings such as ride height and damping.
The coil springs usually bear on a pad alongside the stub-axle. Often, the shock is collinear with the spring forming a coil-over. In many cases, the damper is also used as a restraint strap to stop the arm descending so far that the coil spring falls out through being completely unloaded.
Height adjustable suspension is a feature of certain automobile suspension systems that allow the motorist to vary the ride height or ground clearance. This can be done for various reasons including giving better ground clearance over rough terrain, a lower ground clearance to improve performance and fuel economy at high speed, [1] or for stylistic reasons.
A shock absorber or damper is a mechanical or hydraulic device designed to absorb and damp shock impulses. It does this by converting the kinetic energy of the shock into another form of energy (typically heat) which is then dissipated. Most shock absorbers are a form of dashpot (a damper which resists motion via viscous friction).
Later models would use electronic height sensors and motors so adjustment could be achieved with the engine off. This system allowed the suspension to achieve an unusually soft ride quality. [7] Since then, millions of fairly inexpensive Citroën cars have been equipped with self-levelling as an unobtrusive, but integral design feature.
The shock absorber and coil spring mount to the wishbones to control vertical movement. Double wishbone designs allow the engineer to carefully control the motion of the wheel throughout suspension travel, controlling such parameters as camber angle , caster angle , toe pattern, roll center height, scrub radius , scuff ( mechanical abrasion ...
The package included a total lowered ride height of approximately 2" over stock (1.5" from suspension, ~0.5" from shorter tire diameter), thicker front sway bar (33mm), rear sway bar (23mm), quicker ratio (12:1) steering box, upgraded Decarbon or Bilstein gas shock absorbers, ZQ8 specific bump stops and a frame brace. Some ZQ8 models were also ...