Search results
Results From The WOW.Com Content Network
A fan coil unit (FCU), also known as a Vertical Fan Coil Unit (VFCU), is a device consisting of a heat exchanger (coil) and a fan. FCUs are commonly used in HVAC systems of residential, commercial, and industrial buildings that use ducted split air conditioning or central plant cooling.
Dehumidification (air drying) in an air conditioning system is provided by the evaporator. Since the evaporator operates at a temperature below the dew point, moisture in the air condenses on the evaporator coil tubes. This moisture is collected at the bottom of the evaporator in a pan and removed by piping to a central drain or onto the ground ...
Tube weight was reduced by 31% when copper tube diameters were downsized from 3/8 inch to 7 mm. Tube weight was reduced by 46% when copper tube diameters were downsized from 3/8 inch to 5 mm. The weights of the fin materials in the coils was 3.55 kg for the 9.52 mm coils, 2.61 kg for the 7 mm coils, and 1.55 kg for the 5 mm coils.
That results in a mixture of liquid and vapour at a lower temperature and pressure as shown at point 5. The cold liquid-vapor mixture then travels through the evaporator coil or tubes and is completely vaporized by cooling the warm air (from the space being refrigerated) being blown by a fan across the evaporator coil or tubes.
In the 1990s, Carrier stopped using the "Day & Night" brand (which was the "D" in the BDP division, or Bryant-Day & Night-Payne) but it was revived in 2006 by ICP. In 2001, Carrier was the "world's largest manufacturer of air-conditioning, heating, and refrigerator equipment" with a "total employment of 42,600" and a revenue of $8.9 billion.
Seawater is pumped into an evaporator, where it is boiled by a heating coil. Vapour produced is then compressed, raising its temperature. This heated vapour is used to heat the evaporator coils. Condensate from the coil outlet provides the fresh water supply. To start the cycle, an electric pre-heater is used to heat the first water supply.
A representative pressure–volume diagram for a refrigeration cycle. Vapour-compression refrigeration or vapor-compression refrigeration system (VCRS), [1] in which the refrigerant undergoes phase changes, is one of the many refrigeration cycles and is the most widely used method for air conditioning of buildings and automobiles.
Removing of the circulation pump reduces the operating costs, however due to characteristics of the system as mentioned above the evaporator has a long residence time and low flow rates, [11] making its uses severely more limited than a forced circulation evaporator. The most common application of Natural Circulation evaporation is as a ...