Search results
Results From The WOW.Com Content Network
Dependent on latency class and network speed [citation needed] Unlimited 2 ms or less 192 kHz mLAN: 2000-01 [7] IEEE 1394: Isochronous Coexists with IEEE 1394 IEEE 1394, MIDI Tree Provided by IEEE 1394b IEEE 1394 cable (2 power, 4 signal): 4.5 m 100 m 63 devices (800 Mbit/s) 354.17 μs 192 kHz [l] Optocore [m] Dedicated fiber Synchronous
The specification requires media clocking based on the AVTP CRF (Clock Reference Format) and sample rate of 48 kHz (optionally 96 and 192 kHz); audio stream format is based on AVTP IEC 61883-6 32-bit Standard AAF Audio Format with 1 to 8 audio channels per stream (optionally, 24- and 32-bit High Capacity Format with 56 and 64 channels ...
In the CFP, the AP sends Contention-Free-Poll (CF-Poll) packets to each station, one at a time, to give them the right to send a packet. The AP is the coordinator. Although this allows for a better management of QoS, PCF does not define classes of traffic as is common with other QoS systems (e.g. 802.1p and DiffServ ).
The speed of light imposes a minimum propagation time on all electromagnetic signals. It is not possible to reduce the latency below = / where s is the distance and c m is the speed of light in the medium (roughly 200,000 km/s for most fiber or electrical media, depending on their velocity factor).
The common architecture specification defines a format of nested protocol data units (PDUs), rather similar to TLV encoding, which are used in the main protocols. It then defines how a minimal Root Layer Protocol is used to splice the higher level protocols into a lower level transport and defines such a Root Layer Protocol using the PDU format for use on UDP/IP.
AoE systems use a much higher bit rate (typically 1 Mbit/s per channel) and much lower latency (typically less than 10 milliseconds) than VoIP. AoE requires a high-performance network. Performance requirements may be met through use of a dedicated local area network (LAN) or virtual LAN (VLAN), overprovisioning or quality of service features.
The two are pure packet based networks without traditional voice circuit capabilities. These networks provide voice services via VoIP or VoLTE. Some systems are designed for point-to-point line-of-sight communications, once two such nodes get too far apart they can no longer communicate.
If the DID is equal to 128 (0x80) or greater, then the packet is a Type 1 packet, and the DID is sufficient to identify the packet type, and the following word is a Data Block Number. If the DID is less than 128, it is a Type 2 packet , and the following words is the Secondary Data Identifier; the DID and SDID together identify the packet type.