Ads
related to: 12mm inverted flare adapter for drill press tool shop model zj4116h
Search results
Results From The WOW.Com Content Network
In 1919 the Pennimans filed an unfair trade lawsuit against Eames (Atlas Press Co. v. Eames), claiming rights over the trademark, patent and improved design. The case was argued in front of the Michigan Supreme Court, which ruled that Eames had to cease use of the trademark, but refusing the transfer of the improved press to the Atlas company. [3]
The tool used to flare tubing consists of a die that grips the tube, and either a mandrel or rolling cone is forced into the end of the tube to form the flare by cold working. The most common flare fitting standards in use today are the 45° SAE flare [ 2 ] [ 3 ] ,the 37° JIC flare, and the 37° AN flare.
Guide Pillar & Guide Bush : Used for alignment between top and bottom halves of the press tools. Bottom plate:It is used to hold bottom half of the press tool with press slide. Stripper plate: it is used to strip off the component from punches. Strip guides: It is used to guide the strip into the press tool to perform the operation. Press tool
JIC fittings, defined by the SAE J514 and MIL-DTL-18866 standards, are a type of flare fitting machined with a 37-degree flare seating surface. JIC (Joint Industry Council) fittings are widely used in fuel delivery and fluid power applications, especially where high pressure (up to 10,000 pounds per square inch (690 bar)) is involved.
A drill chuck is a specialised self-centering, three-jaw chuck, usually with capacity of 0.5 in (13 mm) or less, and rarely greater than 1 in (25 mm), used to hold drill bits or other rotary tools. This type of chuck is used on tools ranging from professional equipment to inexpensive hand and power drills for domestic use.
There were 3 different size spring chucks, and therefore 3 different shank size tips or sometimes called points, to fit various models. Generally all tips made by North Brothers or Stanley were stamped with the corresponding number of the model screwdriver they would fit, but the stamped numbers are often difficult to see, so it's a good idea to know the size you need before you set out to ...