Ads
related to: pump shaft material grade
Search results
Results From The WOW.Com Content Network
Typically Grade EN 1.4462 (also called 2205). It is typical of the mid-range of properties and is perhaps the most used today Super-duplex (PREN range: 38–45) Typically grade EN 1.4410 up to so-called hyper duplex grades (PREN: >45) developed later to meet specific demands of the oil and gas as well as those of the chemical industries.
API Standard 682, titled "Pumps - Shaft Sealing Systems for Centrifugal and Rotary Pumps," is the American Petroleum Institute standard for end-face mechanical seals. [1] The purpose of API 682 is to assist in the selection and operation of end face mechanical seals in centrifugal pumps. It is based on the combined knowledge and experience of ...
If a hydraulic rotary pump with the displacement 10 cc/rev is connected to a hydraulic rotary motor with 100 cc/rev, the shaft torque required to drive the pump is one-tenth of the torque then available at the motor shaft, but the shaft speed (rev/min) for the motor is also only one-tenth of the pump shaft speed.
Product grade A washers – with a hardness up to 300 HV designed for use with hexagon head bolts and nuts: Withdrawn: DIN EN ISO 7089, DIN EN ISO 7090: ISO 7089, ISO 7090: DIN 126: Product grade C washers – designed for use with hexagon head bolts and nut: Withdrawn: DIN EN ISO 7091: ISO 7091: DIN 127: Spring lock washers with square ends or ...
Inconel 718 is commonly used for cryogenic storage tanks, downhole shafts, wellhead parts, [44] and in the aerospace industry -- where it has become a prime candidate material for constructing heat resistant turbines. [45]
The material used for ordinary shafts is mild steel. When high strength is required, an alloy steel such as nickel, nickel-chromium or chromium-vanadium steel is used. Shafts are generally formed by hot rolling and finished to size by cold drawing or turning and grinding. [citation needed]